enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fluorescent-lamp formats - Wikipedia

   en.wikipedia.org/wiki/Fluorescent-lamp_formats

   High-lumen retrofit lamps for 40W T12 lamps in North America. Popular tube diameter in Japan; Circular 32W and 40W T10 lamps (Older versions of the 32W and 40W T9 lamps) T12 T38 1 + 1 ⁄ 2: 38.1 G13 bi-pin; Fa8 single-pin; R17d recessed double contact; One of the first diameters of fluorescent lamps, with the 15W T12 and 20W T12 having been ...

3. Bi-pin lamp base - Wikipedia

   en.wikipedia.org/wiki/Bi-pin_lamp_base

   The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...

4. Lightbulb socket - Wikipedia

   en.wikipedia.org/wiki/Lightbulb_socket

   Miniature lamps may have a wedge base made of glass or plastic. The base may be an extension of the glass envelope of the bulb, with the wire leads of the lamp folded up at the base. Some wedge bases are made of plastic and slipped over the wire leads. A wedge base holds the lamp by spring compression in the socket.

5. A-series light bulb - Wikipedia

   en.wikipedia.org/wiki/A-series_light_bulb

   The most commonly used A-series light bulb type is an A60 bulb [7] (or its inch-based equivalent, the A19 bulb [2] [4]), which is 60 mm (19 ⁄ 8 in or 2 + 3 ⁄ 8 in) wide at its widest point [3] and approximately 110 mm (4 + 3 ⁄ 8 in) in length. [8] Other sizes with a data sheet in IEC 60064 are A50, A55, A67, A68, A71, A75, and A80.

6. Incandescent light bulb - Wikipedia

   en.wikipedia.org/wiki/Incandescent_light_bulb

   A 230-volt incandescent light bulb with a medium-sized E27 (Edison 27 mm) male screw base. The filament is visible as the mostly horizontal line between the vertical supply wires. A scanning electron microscope image of the tungsten filament of an incandescent light bulb Elaborate light in Denver, Colorado

7. Edison screw - Wikipedia

   en.wikipedia.org/wiki/Edison_screw

   E14 or E17 are also sometimes used, especially in small table lamps and novelty lighting, and occasionally the lights on newer ceiling fans. 'Christmas lights' use several base sizes: E17 for C9 bulbs, E12 for C7 bulbs, E10 for decades-old series-wired C6 bulb sets [19] in the U.S., and an entirely different wedge base for T1¾ mini-lights. For ...

8. GU24 lamp fitting - Wikipedia

   en.wikipedia.org/wiki/GU24_lamp_fitting

   The GU24 fitting is intended to maintain the energy efficiency of the light by preventing an occupant from using an incandescent bulb instead of a CFL. Adapters to use incandescent bulbs in a GU24 fitting are illegal in the State of California as they would be a fire hazard in fixtures designed for the lower heat output of a CFL bulb. [2]

9. Wedge base - Wikipedia

   en.wikipedia.org/wiki/Wedge_base

   A wedge base is a type of electrical connector used as a fitting for small light bulbs. It is similar to the bi-pin connector , except that the two "pins" are the same wires that extend into the bulb (rather than being rigid), and the wires are bent up onto the sides of the base, where they make contact with the socket.