enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Saline water - Wikipedia

    en.wikipedia.org/wiki/Saline_water

    Seawater has a salinity of roughly 35,000 ppm, equivalent to 35 grams of salt per one liter (or kilogram) of water. The saturation level is only nominally dependent on the temperature of the water. [1] At 20 °C (68 °F) one liter of water can dissolve about 357 grams of salt, a concentration of 26.3 percent by weight (% w/w). At 100 °C (212 ...

  3. Seawater - Wikipedia

    en.wikipedia.org/wiki/Seawater

    The average density at the surface is 1.025 kg/L. Seawater is denser than both fresh water and pure water (density 1.0 kg/L at 4 °C (39 °F)) because the dissolved salts increase the mass by a larger proportion than the volume. The freezing point of seawater decreases as salt concentration increases.

  4. Properties of water - Wikipedia

    en.wikipedia.org/wiki/Properties_of_water

    However, the salt content of oceans lowers the freezing point by about 1.9 °C [41] (due to freezing-point depression of a solvent containing a solute) and lowers the temperature of the density maximum of water to the former freezing point at 0 °C.

  5. Water (data page) - Wikipedia

    en.wikipedia.org/wiki/Water_(data_page)

    The saturated vapor pressure over water in the temperature range of −100 °C to −50 °C is only extrapolated [Translator's note: Supercooled liquid water is not known to exist below −42 °C]. The values have various units (Pa, hPa or bar), which must be considered when reading them.

  6. Salinity - Wikipedia

    en.wikipedia.org/wiki/Salinity

    Salinity is an important factor in determining many aspects of the chemistry of natural waters and of biological processes within it, and is a thermodynamic state variable that, along with temperature and pressure, governs physical characteristics like the density and heat capacity of the water.

  7. Brine - Wikipedia

    en.wikipedia.org/wiki/Brine

    Brine (or briny water) is water with a high-concentration solution of salt (typically sodium chloride or calcium chloride).In diverse contexts, brine may refer to the salt solutions ranging from about 3.5% (a typical concentration of seawater, on the lower end of that of solutions used for brining foods) up to about 26% (a typical saturated solution, depending on temperature).

  8. Why salt melts ice — and how to use it on your sidewalk - AOL

    www.aol.com/news/chemists-told-us-why-salt...

    Anything dissolved in water can have the same effect of lowering the freezing temperature, but salt is used, Ferguson says, because when one unit of salt dissolves, it yields two to three ...

  9. Table of specific heat capacities - Wikipedia

    en.wikipedia.org/wiki/Table_of_specific_heat...

    A Assuming an altitude of 194 metres above mean sea level (the worldwide median altitude of human habitation), an indoor temperature of 23 °C, a dewpoint of 9 °C (40.85% relative humidity), and 760 mmHg sea level–corrected barometric pressure (molar water vapor content = 1.16%). B Calculated values *Derived data by calculation.