Search results
Results from the WOW.Com Content Network
A radio repeater is a combination of a radio receiver and a radio transmitter that receives a signal and retransmits it, so that two-way radio signals can cover longer distances. A repeater sited at a high elevation can allow two mobile stations, otherwise out of line-of-sight propagation range of each other, to communicate. [ 1 ]
An amateur radio repeater system consisting of a 70 cm repeater and a 2-meter digipeater and iGate. Coaxial cavity RF filter at 2 meter repeater An amateur radio repeater is an electronic device that receives a weak or low-level amateur radio signal and retransmits it at a higher level or higher power, so that the signal can cover longer ...
From 29.000 MHz to 29.700, The FM sub-band is usually channelized into repeater and simplex frequencies. The channels are commonly grouped into repeater inputs, simplex, and repeater output frequencies. Repeater input frequencies: 29.510, 29.520, 29.530, 29.540, 29.550, 29.560, 29.570, 29.580 and 29.590 MHz.
Repeaters are the lifeline of the ham radio operator. They are the towers that relay messages between ham radios, accepting the weak incoming signal and then transmitting it at a higher power, so ...
Repeater equipment: GMSK Node Adapter - these devices are hardware GMSK modems with firmware to take D-STAR protocol frames over a USB cable and provide the necessary logic and GMSK modulation to control a simplex node or a full duplex repeater. One repeater that is easily adaptable is the Kenwood TKR-820 as documented by K7VE. [27]
The method is frequently used in ham radio operation, where an operator is attempting to use a repeater station. The repeater station must be able to send and receive a transmission at the same time and does so by slightly altering the frequency at which it sends and receives. This mode of operation is referred to as duplex mode or offset mode.
eQSO is a client–server software program designed by amateur radio enthusiasts for linking amateur radio frequency gateways and repeaters via the internet by using a Voice over IP protocol. It is developed for licence free radios like Citizens Band , PMR446 and Family Radio Service .
WIRES uses DTMF signaling to make a connection over the Internet from a repeater or home station to another WIRES-equipped station that is accessible over the Internet. No proprietary tones or connection formats are used, so any manufacturer's radio (equipped with a DTMF encoding keypad) may be used to bring up the Internet link.