Search results
Results from the WOW.Com Content Network
(For example, if a computer has 2 GB (1024 3 B) of RAM and a 1 GB page file, the operating system has 3 GB total memory available to it.) When the system runs low on physical memory, it can " swap " portions of RAM to the paging file to make room for new data, as well as to read previously swapped information back into RAM.
DDR4 SDRAM was released to the public market in Q2 2014, focusing on ECC memory, [6] while the non-ECC DDR4 modules became available in Q3 2014, accompanying the launch of Haswell-E processors that require DDR4 memory.
DDR2 started to be effective by the end of 2004, as modules with lower latencies became available. [19] Memory manufacturers stated that it was impractical to mass produce DDR1 memory with effective transfer rates in excess of 400 MHz (i.e. 400 MT/s and 200 MHz external clock) due to internal speed limitations.
Historical lowest retail price of computer memory and storage Electromechanical memory used in the IBM 602, an early punch multiplying calculator Detail of the back of a section of ENIAC, showing vacuum tubes Williams tube used as memory in the IAS computer c. 1951 8 GB microSDHC card on top of 8 bytes of magnetic-core memory (1 core is 1 bit.)
Most computer operating systems use the concept of virtual memory, allowing the utilization of more primary storage capacity than is physically available in the system. As the primary memory fills up, the system moves the least-used chunks ( pages ) to a swap file or page file on secondary storage, retrieving them later when needed.
In computing, virtual memory, or virtual storage, [b] is a memory management technique that provides an "idealized abstraction of the storage resources that are actually available on a given machine" [3] which "creates the illusion to users of a very large (main) memory". [4] The computer's operating system, using a combination of hardware and ...
The lower memory clock frequency may also enable power reductions in applications that do not require the highest available data rates. According to JEDEC [5] the maximum recommended voltage is 1.9 volts and should be considered the absolute maximum when memory stability is an issue (such as in servers or other mission critical devices). In ...
Microcontroller devices with integrated I/O and memory on-chip sometimes had no, or a small, address bus available for external devices. For example, a microcontroller family available with a 2 kilobyte address space might have a variant that brought out an 11 line address bus for an external ROM; this could be done by reassigning I/O pins as address bus pins.