Search results
Results from the WOW.Com Content Network
Applies to V.35–V.39. V.35 is an ITU-T standard located on layer 1 on the OSI model. Max speed is 2 Mbit/s and synchronous only. Withdrawn ITU-T recommendation for 48 kbit/s data transmission over wideband circuits. The physical and electrical characteristics of this interface are now specified in ITU-T recommendation V.11.
A/V systems: High-bandwidth Digital Content Protection (HDCP). HDBaseT: 2010: 8P8C: 4096 × 2160 @ 24: A/V systems, data at 10.2 Gbit/s, power up to 100 watts: CoaXPress: BNC connector, DIN 1.0/2.3: Machine vision and industrial cameras: Supports 20.83 Mbit/s uplink channel and power over the same coaxial cable: Mobile High-Definition Link (MHL ...
M1-A EVC cable. The VESA Enhanced Video Connector (EVC) is a VESA standard that was intended to reduce the number of cables around a computer by incorporating video, audio, FireWire and USB into a single cable system, terminating in a 35-pin Molex MicroCross connector. The intent was to make the monitor the central point of connection.
Selection of one over the other rests mainly on the availability of appropriate connectors on the chosen equipment and the preference and convenience of the user. Connections longer than 6 meters or so, or those requiring tight bends, should use coaxial cable, since the high light signal attenuation of TOSLINK cables limits its effective range.
Cables should meet the S/PDIF specification as defined by the international standard IEC 60958-3 for assured performance. The male plug has a center pin that is 1 ⁄ 8 inch (3.175 mm) in diameter, and is surrounded by an outer shell that is 1 ⁄ 3 inch (8.47 mm) in diameter.
A cable color scheme, known as even-count color code, is determined for 25 pairs of conductors as follows: [8] For each ring, the primary, more prominent color is chosen from the set blue, orange, green, brown, and slate, in that order, and the secondary, thinner stripe color from the set of white, red, black, yellow, and violet colors, in that ...
To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...
Perhaps the most comprehensive known and most discussed feature of ANSI/TIA-568 is the definition of the pin-to-pair assignments, or pinout, between the pins in a connector (a plug or a socket) and the wires in a cable. Pinouts are critical because cables do not function if the pinouts at their two ends aren't correctly matched.