Search results
Results from the WOW.Com Content Network
A submetering system typically includes a "master meter", which is owned by the utility supplying the water, electricity, or gas, with overall usage billed directly to the property owner. The property owner or manager then places their own private meters on individual tenant spaces to determine individual usage levels and bill each tenant for ...
In electrical engineering, an electrical isolation test is a direct current (DC) or alternating current (AC) resistance test that is performed on sub-systems of an electronic system to verify that a specified level of isolation resistance is met.
To measure resistance, switches arrange for a small battery within the instrument to pass a current through the device under test and the meter coil. Since the current available depends on the state of charge of the battery which changes over time, a multimeter usually has an adjustment for the ohm scale to zero it.
The meter communicates to its collection point using 900 MHz mesh network topology. Automatic meter reading (AMR) is the technology of automatically collecting consumption, diagnostic, and status data from water meter or energy metering devices (gas, electric) and transferring that data to a central database for billing, troubleshooting, and ...
Capacitance meter: Measures the capacitance component Current clamp: Measures current without physical connection Curve tracer: Applies swept signals to a device and allows display of the response Cos Phi Meter: Measures the power factor Distortionmeter: Measures the distortion added to a circuit Electricity meter: Measures the amount of energy ...
The open metering system of the Open Metering System Group e.V. stands for a manufacturer- and media-independent standardization for Meter-Bus (M-Bus) based communication between utility meters (electricity, gas, water, thermal energy), submetering (cold/hot water, thermal energy, heat cost allocators), and systems in the field of smart meters.
Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...
Avometer 15 Volt BLR121 battery. AVOmeter is a British trademark for a line of multimeters and electrical measuring instruments; the brand is now owned by the Megger Group Limited. The first Avometer was made by the Automatic Coil Winder and Electrical Equipment Co. in 1923, and measured direct voltage, direct current and resistance. [1]