Search results
Results from the WOW.Com Content Network
A submetering system typically includes a "master meter", which is owned by the utility supplying the water, electricity, or gas, with overall usage billed directly to the property owner. The property owner or manager then places their own private meters on individual tenant spaces to determine individual usage levels and bill each tenant for ...
In electrical engineering, an electrical isolation test is a direct current (DC) or alternating current (AC) resistance test that is performed on sub-systems of an electronic system to verify that a specified level of isolation resistance is met.
A digital clamp meter A multimeter with built-in clamp. Pushing the large button at the bottom opens the lower jaw of the clamp, allowing the clamp to be placed around a conductor. An electrical meter with integral AC current clamp is known as a clamp meter, clamp-on ammeter, tong tester, or colloquially as an amp clamp.
Capacitance meter: Measures the capacitance component Current clamp: Measures current without physical connection Curve tracer: Applies swept signals to a device and allows display of the response Cos Phi Meter: Measures the power factor Distortionmeter: Measures the distortion added to a circuit Electricity meter: Measures the amount of energy ...
Analog multimeter Digital multimeter. A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [2] [3] A typical multimeter can measure voltage, resistance, and current, [4] in which case can be used as a voltmeter, ohmmeter, and ammeter.
A second switch brought a rheostat into circuit in series with the instrument and could be used to control the current through a device under test and the meter. The movement drew 12 mA for full-scale deflection and used a "universal shunt" permanently in parallel with the movement which increased the input terminal full-scale current to 16.6 ...
Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...
A push switch (button) is a momentary or non-latching switch which causes a temporary change in the state of an electrical circuit only while the switch is physically actuated. An automatic mechanism (i.e. a spring ) returns the switch to its default position immediately afterwards, restoring the initial circuit condition.