Search results
Results from the WOW.Com Content Network
A tube-shaped connector with two crimps for splicing wires in-line is called a butt splice connector. Single-wire crimp terminals include: Blade or quick disconnect (e.g., Faston or Lucar) Bullet (e.g. Shur-Plug) Butt splice; Flag tongue; Rectangular tongue; Hook tongue; Spade tongue (flanged, short spring, long spring) Ring tongue (slotted ...
For hoses and piping, a quick connect fitting, also called a push fitting, is a coupling used to provide a fast, make-or-break connection of gas or liquid transfer lines. Operated by hand, quick connect fittings replace threaded or flanged connections, which require wrenches. When equipped with self-sealing valves, quick connect fittings will ...
The connector family was created by the Quick Lock Formula Alliance, which consists of Huber+Suhner, Radiall, Rosenberger Hochfrequenztechnik, and Amphenol. QMA [1] and QN [2] connectors are the quick lock version of SMA and N connectors. This design can save much handling time because it allows quick mating and demating without tools.
LC (top) and ST (bottom) optical fiber connectors, both with protective caps in place. An optical fiber connector is a device used to link optical fibers, facilitating the efficient transmission of light signals. An optical fiber connector enables quicker connection and disconnection than splicing.
To isolate the splice, an insulating sleeve made of paper or plastic is pushed over it. The splicing of copper wires is mainly used on paper insulated wires. LSA techniques (LSA: soldering, screwing and stripping free) are used to connect copper wires, making the copper wires faster and easier to connect. LSA techniques include:
The splice cassette is removable in order to assemble fiber optics with a splice unit. The front panel can also be removed to splice the fibers to various connectors. Since modern splice cassettes already contain a splice tray, a splice holder, couplings and pigtails, the installation of the cables is
A push-in compression coupling and tee.. Push-to-pull, push-to-connect, push-in, push-fit, or instant fittings are a type of easily removed compression fitting or quick connect fitting that allows an air (or water) line to be attached, nominally without the use of tools (a tool is still usually required for cutting tubing to length and removal).
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.