Search results
Results from the WOW.Com Content Network
Routers treat the ECT(0) and ECT(1) codepoints as equivalent. If the packet traverses an active queue management (AQM) queue (e.g., a queue that uses random early detection (RED)) that is experiencing congestion and the corresponding router supports ECN, it may change the code point to CE instead of dropping the packet .
However, due to functional limitations, it is intended by Cisco to be used only as a learning aid, not a replacement for Cisco routers and switches. [9] The application itself only has a small number of features found within the actual hardware running a current Cisco IOS version. Thus, Packet Tracer is unsuitable for modelling production networks.
If a packet is sent to 203.0.113.1 by a computer at 192.168.1.100, the packet would normally be routed to the default gateway (the router) [e] A router with the NAT loopback feature detects that 203.0.113.1 is the address of its WAN interface, and treats the packet as if coming from that interface. It determines the destination for that packet ...
The router which first prefixes the MPLS header to a packet is an ingress router. The last router in an LSP, which pops the label from the packet, is called an egress router. Routers in between, which need only swap labels, are called transit routers or label switch routers (LSRs).
During normal operation, routers send hello messages to their neighbors at regular intervals (the hello interval); if a router stops receiving hello messages from a neighbor, after a set period (the dead interval) the router will assume the neighbor has gone down.
Convergence is the state of a set of routers that have the same topological information about the internetwork in which they operate. For a set of routers to have converged, they must have collected all available topology information from each other via the implemented routing protocol, the information they gathered must not contradict any other router's topology information in the set, and it ...
Cisco's IOS software maintains one IDB for each hardware interface in a particular Cisco switch or router and one IDB for each subinterface. The number of IDBs present in a system varies with the Cisco hardware platform type. Physical and logical interfaces on the switch will be referenced with either expanded or abbreviated port description names.
The all-zeroes address is reserved as the subnet-router anycast address. [18] The subnet router anycast address is the lowest address in the subnet, so it looks like the “network address”. If a router has multiple subnets on the same link, then it has multiple subnet router anycast addresses on that link. [19]