enow.com Web Search

  1. Ads

    related to: aluminum square rods 1 2 5

Search results

  1. Results from the WOW.Com Content Network
  2. 6105 aluminium alloy - Wikipedia

    en.wikipedia.org/wiki/6105_aluminium_alloy

    6105 aluminium alloy is an alloy in the wrought aluminium-magnesium-silicon family (6000 or 6xxx series). It is one of the least common of the alloys in this series. While most wrought aluminium alloys are covered by multiple standards (from any mixture of ASTM, EN, ISO, and national standard bodies), 6105 is only dealt with in ASTM B221: Standard Specification for Aluminum and Aluminum-Alloy ...

  3. T-slot structural framing - Wikipedia

    en.wikipedia.org/wiki/T-slot_structural_framing

    T-slot framing is divided into metric and fractional (imperial) categories. The T-slot is always centered along the long-axis of the piece. Pieces are available in each series with a square cross-section. Rectangular cross sections are also available which measure x by 2x (where x is the defined width) - e.g. 40mm by 80mm for 40 series.

  4. Semi-finished casting products - Wikipedia

    en.wikipedia.org/wiki/Semi-finished_casting_products

    A billet is a length of metal that has a round or square cross-section, with an area less than 36 in 2 (230 cm 2). Billets are created directly via continuous casting or extrusion or indirectly via hot rolling an ingot or bloom. [1] [2] [4] Billets are further processed via profile rolling and drawing. Final products include bar stock and wire. [3]

  5. Bar stock - Wikipedia

    en.wikipedia.org/wiki/Bar_stock

    Drill rod diameters range from 0.0135 to 1.5 in (0.34 to 38.10 mm); in the United States diameters smaller than 27 ⁄ 64 th of an inch (11 mm) are made in letter drill sizes and number drill sizes, in addition to fractional sizes. Lengths are usually one or three feet (0.3048 or 0.9144 m).

  6. Kaiser Aluminum - Wikipedia

    en.wikipedia.org/wiki/Kaiser_Aluminum

    The wire mill trains started out with 12 feet long and 6 inches square ingots, cut down to pieces of 70-inch length and then rolled on the 10-inch mill into a 3/8-inch rod nearly 1/2 mile long in 55 seconds, in total 235,000 pounds per shift. Rods and bars were either sold, or rods were used to make wires up to 0.0056 inches thin.

  7. Aluminium–magnesium alloys - Wikipedia

    en.wikipedia.org/wiki/Aluminium–magnesium_alloys

    For example, with a true elongation of 0.2, AlMg0.5 has a flow voltage of about 100 N/mm 2, AlMg one of 150 N/mm 2, AlMg 3 of 230 N/mm 2 and AlMg4.5Mn0.4 of about 300 N/mm 2. The higher the alloy content and the greater the elongation, the greater the resulting PLC effect and the Lüders effect .

  1. Ads

    related to: aluminum square rods 1 2 5