Search results
Results from the WOW.Com Content Network
A waveguide junction circulator used as an isolator by placing a matched load on port 3. The label on the permanent magnet indicates the direction of circulation. Microwave circulators fall into two main classes: differential phase shift circulators and junction circulators, both of which are based on cancellation of waves propagating over two different paths in or near magnetized ferrite ...
The following parameters are characteristic for the circulating pumps: capacity Q, pump pressure ∆p (delivery head ∆H), energy consumption P with pump unit efficiency η, impeller rotational speed n, NPSH and sound level L. In practice, the graphical relationship between the values Q, ∆ p(∆H), P and η is used.
Motion of fluid above and below a moving object is forced to circulate, and are thus restricted to be within a column extended by the object in the axis of rotation. A Taylor column is a fluid dynamics phenomenon that occurs as a result of the Coriolis effect. It was named after Geoffrey Ingram Taylor. Rotating fluids that are perturbed by a ...
Circulator-based isolator. The circulation mechanism induced by the ferrite in the cavity constrains the signal to flow from port 1 to port 2 and from port 2 to port 3. However, the port 3 is connected to a matched load. All the incoming signal is then absorbed and no signal can be emitted from port 3.
A thermal immersion circulator comprises a circulator pump or motorized impeller to move the fluid, a heating element immersed in the fluid, an accurate temperature probe, and control circuitry which compares the measured temperature with the desired value and supplies power to the heater as required to stabilize the temperature.
Natural circulation requires vertical piping whereas the forced circulation ensures flow in any direction. [6] The walls of the tube may be built smaller due to the greater tolerance of higher pressure losses. [6] The general forced circulation boiler has a low circulation ratio of range between three and ten.
Optical Circulator symbol. An optical circulator is a three- or four-port optical device designed such that light entering any port exits from the next. This means that if light enters port 1 it is emitted from port 2, but if some of the emitted light is reflected back to the circulator, it does not come out of port 1 but instead exits from port 3.
The oil burner nozzle is usually mounted in the front of the firebox, protected by a hood of firebrick, and aimed at the firebrick wall below the firebox door. Dampers control air flow to the oil fire. Schematic of a later steam locomotive firebox boiler, with firebox to the left and indicatively showing two superheater elements to the right.