Search results
Results from the WOW.Com Content Network
millivolt 10 3 V kV kilovolt 10 −6 V μV microvolt 10 6 V MV megavolt 10 −9 V nV nanovolt 10 9 V GV gigavolt 10 −12 V pV picovolt 10 12 V TV teravolt 10 −15 V fV femtovolt 10 15 V PV petavolt 10 −18 V aV attovolt 10 18 V EV exavolt 10 −21 V zV zeptovolt 10 21 V ZV zettavolt 10 −24 V yV yoctovolt 10 24 V YV yottavolt 10 −27 V rV
The conversion of conductivity (in μS/cm) to the total dissolved solids (in mg/kg) depends on the chemical composition of the sample and can vary between 0.54 and 0.96. Typically, the conversion is done assuming that the solid is sodium chloride; 1 μS/cm is then equivalent to about 0.64 mg of NaCl per kg of water.
The siemens (symbol: S) is the unit of electric conductance, electric susceptance, and electric admittance in the International System of Units (SI). Conductance, susceptance, and admittance are the reciprocals of resistance, reactance, and impedance respectively; hence one siemens is equal to the reciprocal of one ohm (Ω −1) and is also referred to as the mho.
The electric field strength at a specific point can be determined from the power delivered to the transmitting antenna, its geometry and radiation resistance. Consider the case of a center-fed half-wave dipole antenna in free space, where the total length L is equal to one half wavelength (λ/2).
The Smith chart (sometimes also called Smith diagram, Mizuhashi chart (水橋チャート), Mizuhashi–Smith chart (水橋スミスチャート), [1] [2] [3] Volpert–Smith chart (Диаграмма Вольперта—Смита) [4] [5] or Mizuhashi–Volpert–Smith chart) is a graphical calculator or nomogram designed for electrical and electronics engineers specializing in radio ...
The term was coined by C.P. Steinmetz in a 1894 paper. [1]In some sources Oliver Heaviside is given credit for coining the term, [2] or with introducing the concept under the name permittance. [3]
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
The sensitivity of a microphone is usually expressed as the sound field strength in decibels (dB) relative to 1 V/Pa (Pa = N/m 2) or as the transfer factor in millivolts per pascal (mV/Pa) into an open circuit or into a 1 kiloohm load. [citation needed] The sensitivity of a hydrophone is usually expressed as dB relative to 1 V/μPa. [7]