Ads
related to: steps to wipe bottom properly before running a bike chain replacement
Search results
Results from the WOW.Com Content Network
Bicycle chains Roller chain and sprocket. A bicycle chain is a roller chain that transfers power from the pedals to the drive-wheel of a bicycle, thus propelling it.Most bicycle chains are made from plain carbon or alloy steel, but some are nickel-plated to prevent rust, or simply for aesthetics.
Bottom bracket wrench for newer bottom bracket styles Crank extractor. A chain tool or chain splitter is used to 'break' a chain, in order to remove it from a bike or remove links, or to put a chain back together. A crank extractor is used to pull the crank off the bottom bracket spindle. A pedal wrench removes the pedals from the bicycle. It ...
A typical chain tool. With a chain placed on the central sprocket, the screw is turned until a pin is pushed from the linkage. A chain tool is a small mechanical device used to "break" a bicycle chain in such a way that it can be mended with the same tool. A bicycle chain has links and plates that are pinned together; these pins can be pushed ...
Skip-link chain is an obsolete roller chain for bicycles in which side plates are alternately short and long, and so rollers are alternately close together and far apart. A skip-link chain running over the rear sprocket on a bicycle. In bicycle chains, skip-link chain has the same one-inch spacing as the earlier block chain. Due to the ...
Seat tube: the roughly vertical tube in a bicycle frame running from the seat to the bottom bracket; Seat bag: a small storage accessory hung from the back of a seat; Seatpost: a post that the seat is mounted to. It slides into the frame's seat tube and is used to adjust ride height depending how far into the seat tube it is inserted
A Rohloff Speedhub hub gear A Shimano XT rear derailleur on a mountain bike A bicycle gearbox with chain tensioner. Bicycle gearing is the aspect of a bicycle drivetrain that determines the relation between the cadence, the rate at which the rider pedals, and the rate at which the drive wheel turns.
The plug is machined to accept a typical bottom bracket, but offset from the center of the plug, so that by rotating the plug, the location of the bottom bracket (and hence the chain tension) may be adjusted (fore and aft to tension the chain, the upper or lower eccentric position for a given chain length can be chosen to fine tune bottom ...
In the single-chain system, the chain runs from the top of a chainring attached to the cranks to the top of a sprocket attached to the rear wheel hub with a freewheel, as with most bicycle chain drives. The chain then, usually, wraps around the rear sprocket to an idler sprocket between the rear wheel and the cranks, then runs back to a second ...
Ads
related to: steps to wipe bottom properly before running a bike chain replacement