enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Push-to-pull compression fittings - Wikipedia

   en.wikipedia.org/wiki/Push-to-pull_compression...

   A new grab washer was required each time if a joint was reused. The fittings were designed for use with polybutylene pipe, while stainless steel pipe inserts were used for internal support. Hepworth was acquired by Wavin in 2005. [1] Hep2O changed material and design in the 2000s to a smooth white plastic and a push-to-demount design.

3. Compression fitting - Wikipedia

   en.wikipedia.org/wiki/Compression_fitting

   A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

4. Grinnell Mechanical Products - Wikipedia

   en.wikipedia.org/wiki/Grinnell_Mechanical_Products

   Grinnell grooved products include grooved couplings, grooved fittings, mechanical tees, valves, circuit balancing valves, copper systems, stainless steel systems, plain end systems, HDPE systems, PVC systems, G-PRESS systems, gaskets and spare parts, and preparation equipment, as well as accessories, such as strainers, tee strainers, suction diffusers, dielectric waterway transition fittings ...

5. Hose clamp - Wikipedia

   en.wikipedia.org/wiki/Hose_clamp

   The hose is then fit onto the barb, the clamp expanded again, slid onto the portion of the hose over the barb, then released, compressing the hose onto the barb. Clamps of this design are rarely used for high pressures or large hoses, as they would require unwieldy amounts of steel to generate enough clamping force, and be impossible to work ...

6. Hose coupling - Wikipedia

   en.wikipedia.org/wiki/Hose_coupling

   A selection of Storz hose couplings. A hose coupling is a connector on the end of a hose to connect (or couple) it with another hose or with a tap or a hose appliance, such as an irrigation sprinkler. It is usually made of steel, brass, stainless steel, aluminium or plastic.

7. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   The bodies of fittings for pipe and tubing are often the same base material as the pipe or tubing connected: copper, steel, PVC, CPVC, or ABS. Any material permitted by the plumbing, health, or building code (as applicable) may be used, but it must be compatible with the other materials in the system, the fluids being transported, and the ...