enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Grain per gallon - Wikipedia

   en.wikipedia.org/wiki/Grain_per_gallon

   The grain per gallon (gpg) is a unit of water hardness defined as 1 grain (64.8 milligrams) of calcium carbonate dissolved in 1 US gallon of water (3.785412 L). It translates into 1 part in about 58,000 parts of water or 17.1 parts per million (ppm). Also called Clark degree (in terms of an imperial gallon).

3. Hard water - Wikipedia

   en.wikipedia.org/wiki/Hard_water

   The permanent hardness of water is determined by the water's concentration of cations with charges greater than or equal to 2+. Usually, the cations have a charge of 2+, i.e., they are divalent. Common cations found in hard water include Ca 2+ and Mg 2+, which frequently enter water supplies by leaching from minerals within aquifers.

4. dGH - Wikipedia

   en.wikipedia.org/wiki/DGH

   In water testing hardness is often measured in parts per million (ppm), where one part per million is defined as one milligram of calcium carbonate (CaCO 3) per litre of water. Consequently, 1 dGH corresponds to 10 ppm CaO but 17.848 ppm CaCO 3 which has a molar mass of 100.09 g/mol.

5. Carbonate hardness - Wikipedia

   en.wikipedia.org/wiki/Carbonate_hardness

   Carbonate hardness, is a measure of the water hardness caused by the presence of carbonate (CO 2− 3) and bicarbonate (HCO − 3) anions. Carbonate hardness is usually expressed either in degrees KH (from the German "Karbonathärte"), or in parts per million calcium carbonate ( ppm CaCO 3 or grams CaCO 3 per litre|mg/L).

6. Total dissolved solids - Wikipedia

   en.wikipedia.org/wiki/Total_dissolved_solids

   14] Water can be classified by the level of total dissolved solids (TDS) in the water: Fresh water: TDS is less than 1,000 ppm. Brackish water: TDS = 1,000 to 10,000 ppm. Saline water: TDS = 10,000 to 35,000 ppm. Hypersaline: TDS greater than 35,000 ppm. Drinking water generally has a TDS below 500 ppm.

7. Total suspended solids - Wikipedia

   en.wikipedia.org/wiki/Total_suspended_solids

   TSS of a water or wastewater sample is determined by pouring a carefully measured volume of water (typically one litre; but less if the particulate density is high, or as much as two or three litres for very clean water) through a pre-weighed filter of a specified pore size, then weighing the filter again after the drying process that removes all water on the filter.

8. The 7 Best Laundry Detergents for Hard Water - AOL

   www.aol.com/entertainment/7-best-laundry...

   First up on our list of the 7 best laundry detergent for hard water is Loni Bio Laundry Detergent. This fragrance free option comes in a 75 washer load option that uses natural ingredients and ...

9. Water flow test - Wikipedia

   en.wikipedia.org/wiki/Water_flow_test

   where: [2] Q f = total residual flow during the test (gallons per minute); c = discharge coefficient (unitless). This is usually 1.0 if using a diffuser. If using a wand to measure the stagnation pressure, the coefficient value depends on the shape of the flow hydrant orifice.