Search results
Results from the WOW.Com Content Network
The van der Pauw Method is a technique commonly used to measure the resistivity and the Hall coefficient of a sample. Its strength lies in its ability to accurately measure the properties of a sample of any arbitrary shape, as long as the sample is approximately two-dimensional (i.e. it is much thinner than it is wide), solid (no holes), and the electrodes are placed on its perimeter.
A work method statement, sometimes referred to as a safe work method statement or SWMS or a safe work procedure, is a part of a workplace safety plan. [1] It is primarily used in construction to describe a document that gives specific instructions on how to safely perform a work related task, or operate a piece of plant or equipment.
It aims to allow application software to exchange information about an electrical network. [1] It has been officially adopted by the International Electrotechnical Commission (IEC). The CIM is currently maintained as a UML model. [2] It defines a common vocabulary and basic ontology. CIM models the network itself using the 'wires model'.
Kirchhoff's current law is the basis of nodal analysis. In electric circuits analysis, nodal analysis, node-voltage analysis, or the branch current method is a method of determining the voltage (potential difference) between "nodes" (points where elements or branches connect) in an electrical circuit in terms of the branch currents.
Mesh analysis (or the mesh current method) is a circuit analysis method for planar circuits. Planar circuits are circuits that can be drawn on a plane surface with no wires crossing each other. A more general technique, called loop analysis (with the corresponding network variables called loop currents ) can be applied to any circuit, planar or ...
A sample is a physical portion of the specified product. Some samples are full product samples, such as a brick or section of precast concrete, or a partial sample that indicates color or texture. [2] The product sample is often required when several products are acceptable, to confirm the quality and aesthetic level of the material.
On-site electrical resistivity of concrete is commonly measured using four probes in a Wenner array. The reason for using four probes is the same as in the laboratory method - to overcome contact errors. In this method four equally spaced probes are applied to the specimen in a line.
There is an underlying assumption to this method that the total current or voltage is a linear superposition of its parts. Therefore, the method cannot be used if non-linear components are present. [2]: 6–14 Superposition of powers cannot be used to find total power consumed by elements even in linear circuits. Power varies according to the ...