Search results
Results from the WOW.Com Content Network
The SIG Sauer 200 STR has an 11 mm dovetail on the receiver for mounting a diopter rear sight or a scope sight, either directly or via a Picatinny rail adapter. Dovetails come in several different types and sizes depending on manufacturer, but the most common are the 11 mm and 3 ⁄ 8 inch (9.5 mm).
The Advanced Target Pointer Illuminator Aiming Laser, ATPIAL AN/PEQ-15 known colloquially as the "PEQ-15" [/ p ɛ k / / f ɪ f t iː n /] produced by L3Harris (originally designed and manufactured by Insight Technology, until their acquisition by L3Harris in 2010); is a multifunction IR Target Pointer & Illuminator, a.k.a. a Laser Aiming Module (LAM) for use as a rifle attachment, using a ...
Pistol version is designed with a Neilsen which allows it to be used with most of the common John Browning tilting-barrel designs, including the swinging-linked M1911 and the cam-lock system operated Glock pistols. The Neilsen is an assembly in the aft end of the suppressor that allows the gasses to push the suppressor forward while allowing ...
A view through a Tasco ProPoint red dot sight. The mid- to late 1970s saw the introduction of what are usually referred to as red dot sights, a type that gives the user a simple bright red dot as an aiming point. [27] The typical configuration for this sight is a compact curved mirror reflector design with a red light-emitting diode (LED) at ...
It is similar in concept to the earlier commercial Weaver rail mount used to mount telescopic sights, but is taller and has wider slots at regular intervals along the entire length. The MIL-STD-1913 locking slot width is 0.206 in (5.23 mm). The spacing of slot centres is 0.394 in (10.01 mm) and the slot depth is 0.118 in (3.00 mm). [8]
A base can thus sometimes constitute a complete scope mount assembly, but is most often used to refer to the lower part of a two-part scope mount assembly. The firearm interface which sits on the firearm and to which the scope mount is attached is often called the base or rail. Some types of bases are: Standard mounts
The locking bar system allows for even stress to be distributed and prevent canting of the scope mount. Another form of scope canting is caused by the rings themselves. Many Weaver-type mounts, including many Picatinny-type scope rings and even the Redfield Type, have either two or four screws on top of the scope ring that hold the scope in place.
The scope base is the attachment interface on the rifle's receiver, onto which the scope rings or scope mount are fixed. Early telescopic sights almost all have the rings that are fastened directly into tapped screw holes on the receiver, hence having no additional scope base other than the receiver top itself.