Search results
Results from the WOW.Com Content Network
The pavement condition index (PCI) is a numerical index between 0 and 100, which is used to indicate the general condition of a pavement section.The PCI is widely used in transportation civil engineering [1] and asset management, and many municipalities use it to measure the performance of their road infrastructure and their levels of service. [2]
The PASER scale is a 1-10 rating system for road pavement condition developed by the University of Wisconsin-Madison Transportation Information Center. PASER uses visual inspection to evaluate pavement surface conditions. When assessed correctly, PASER ratings provide a basis for comparing the quality of roadway segments. [1]
When evaluating the series of tests, it was found that there is a connection between the thickness of the pavement, the number of load transfers and the axle load, and that these have a direct effect on the service life and condition of a road. The service life of the road is thereby reduced with approximately the fourth power of the axle load. [1]
A falling weight deflectometer, towed by a truck. A falling weight deflectometer (FWD) is a testing device used by civil engineers to evaluate the physical properties of pavement in highways, local roads, airport pavements, harbor areas, railway tracks and elsewhere. The data acquired from FWDs is primarily used to estimate pavement structural ...
For rigid pavements, design the pavement to resist a standard flexural stress of 2.75 MPa at the bottom of the cement concrete layer according to the LEA design procedure; Calculate the single wheel load with a tire pressure of 1.50 MPa that would require the same pavement structural cross-section, this is the Derived Single Wheel Load (DSWL)
The Aircraft Classification Number (ACN) – Pavement Classification Number (PCN) method is a standardized international airport pavement rating system promulgated by the ICAO in 1981. The method has been the official ICAO pavement rating system for pavements intended for aircraft of apron (ramp) mass greater than 5700 kg from 1981 to 2020. [ 1 ]
The Pavement Condition Index (PCI) is an example of an engineering approach applied to existing pavements. Another example is the use of a falling weight deflectometer (FWD) to non-destructively test existing pavements. Calculation of pavement layer strengths can be performed from the resulting deflection data.
The standard rail weight for British railways is now 113 lb/yd (56.1 kg/m). Before the 1990s, most diesel locomotives were built to a maximum axle load of 19 long tons (19.3 tonnes; 21.3 short tons) so the maximum locomotive weight was 76 long tons (77.2 tonnes; 85.1 short tons) for a four-axle locomotive and 114 long tons (115.8 tonnes; 127.7 short tons) for a six-axle one.