Search results
Results from the WOW.Com Content Network
Parts in this section have a pin count of 14 pins or more. The lower part numbers were established in the 1960s and 1970s, then higher part numbers were added incrementally over decades. IC manufacturers continue to make a core subset of this group, but many of these part numbers are considered obsolete and no longer manufactured.
The first part number in the series, the 7400, is a 14-pin IC containing four two-input NAND gates. Each gate uses two input pins and one output pin, with the remaining two pins being power (+5 V) and ground. This part was made in various through-hole and surface-mount packages, including flat pack and plastic/ceramic dual in-line.
The 7400 series devices have been produced on a number of different manufacturing processes, but have retained the same pinouts throughout. For example, all 7405 devices provide six NOT gates (or inverters) but may have incompatible supply voltage tolerances. 7405 – Standard TTL, 4.75–5.25 V. 74C05 – CMOS, 4–15 V.
The 74HC00 family followed, and improved upon, the 74C00 series (which provided an alternative CMOS logic family to the 4000 series but retained the part number scheme and pinouts of the standard 7400 series (especially the 74LS00 series)) . Some specifications include: [1] DC supply voltage; DC input voltage range; DC output voltage range
IC power-supply pins are voltage and current supply terminals found on integrated circuits (ICs) in electrical engineering, electronic engineering, and integrated circuit design. [ a ] ICs have at least two pins that connect to the power rails of the circuit in which they are installed.
For example, the 7404 TTL chip which has 14 pins and the 4049 CMOS chip which has 16 pins, 2 of which are used for power/referencing, and 12 of which are used by the inputs and outputs of the six inverters (the 4049 has 2 pins with no connection).
The codes given in the chart below usually tell the length and width of the components in tenths of millimeters or hundredths of inches. For example, a metric 2520 component is 2.5 mm by 2.0 mm which corresponds roughly to 0.10 inches by 0.08 inches (hence, imperial size is 1008).
The standard 4000 series CMOS IC is the 4071, which includes four independent two-input OR gates. The TTL device is the 7432. The TTL device is the 7432. There are many offshoots of the original 7432 OR gate, all having the same pinout but different internal architecture, allowing them to operate in different voltage ranges and/or at higher speeds.