Search results
Results from the WOW.Com Content Network
In this way, UDP provides application multiplexing. A port is a software structure that is identified by the port number, a 16-bit integer value, allowing for port numbers between 0 and 65535. Port 0 is reserved but is a permissible source port value if the sending process does not expect messages in response.
In computer networking, the Reliable User Datagram Protocol (RUDP) is a transport layer protocol designed at Bell Labs for the Plan 9 operating system.It aims to provide a solution where UDP is too primitive because guaranteed-order packet delivery is desirable, but TCP adds too much complexity/overhead.
UDP hole punching is a method for establishing bidirectional UDP connections between Internet hosts in private networks using network address translators. The technique is not applicable in all scenarios or with all types of NATs, as NAT operating characteristics are not standardized.
UDP User Datagram Protocol: RFC 768: 0x12 18 MUX Multiplexing: IEN 90 [3] 0x13 19 DCN-MEAS DCN Measurement Subsystems 0x14 20 HMP Host Monitoring Protocol: RFC 869: 0x15 21 PRM Packet Radio Measurement 0x16 22 XNS-IDP XEROX NS IDP 0x17 23 TRUNK-1 Trunk-1 0x18 24 TRUNK-2 Trunk-2 0x19 25 LEAF-1 Leaf-1 0x1A 26 LEAF-2 Leaf-2 0x1B 27 RDP Reliable ...
A value used by receivers to determine the maximum backoff timer value when using timer-based NORM NACK feedback suppression mechanisms. gsize (4 bits) The sender's current estimate of group size. flags (32 bits) Binary flags providing information to assist the receiver in appropriately handling the payload. fec_id The FEC Encoding Identifier.
Cisco's implementation of traceroute also uses a sequence of UDP datagrams, each with incrementing TTL values, to an invalid port number at the remote host; by default, UDP port 33434 is used. An extended version of this command (known as the extended traceroute command) can change the destination port number used by the UDP probe messages. [13]
This is a list of TCP and UDP port numbers used by protocols for operation of network applications. The Transmission Control Protocol (TCP) and the User Datagram Protocol (UDP) only need one port for bidirectional traffic. TCP usually uses port numbers that match the services of the corresponding UDP implementations, if they exist, and vice versa.
Together, Transmission Control Protocol (TCP) and IP provide a reliable service, whereas User Datagram Protocol (UDP) and IP provide an unreliable one. In the context of distributed protocols, reliability properties specify the guarantees that the protocol provides with respect to the delivery of messages to the intended recipient(s).