Search results
Results from the WOW.Com Content Network
The United States adopted the conversion factor 1 metre = 39.37 inches by an act in 1866. [30] In 1893, Mendenhall ordered the physical realization of the inch to be based on the international prototype metres numbers 21 and 27, which had been received from the CGPM, together with the previously adopted conversion factor. [31]
Wine was measured with units based on the wine gallon of 231 cubic inches (3.785 L), beer was measured with units based on an ale gallon of 282 cubic inches (4.621 L) and grain was measured with the Winchester measure with a gallon of approximately 268.8 cubic inches (one eighth of a Winchester bushel or 4.405 L). In 1824, these units were ...
The basic unit of length in the imperial and U.S. customary systems is the yard, defined as exactly 0.9144 m by international treaty in 1959. [2] [10] Common imperial units and U.S. customary units of length include: [11] thou or mil (1 ⁄ 1000 of an inch) inch (25.4 mm) foot (12 inches, 0.3048 m) yard (3 feet, 0.9144 m)
The U.S. government passed the Metric Conversion Act of 1975, which made the metric system "the preferred system of weights and measures for U.S. trade and commerce". The legislation states that the federal government has a responsibility to assist industry as it voluntarily converts to the metric system, i.e., metrification. This is most ...
Length; system unit code (other) symbol or abbrev. notes conversion factor/m combinations SI: gigametre: Gm Gm US spelling: gigameter 1.0 Gm (620,000 mi) megametre: Mm Mm US spelling: megameter
The US Customary system of units makes use of set of dry units of capacity that have a similar set of names [Note 7] to those of liquid capacity, though different volumes: the dry pint having a volume of 33.6 cubic inches (550 ml) against the US fluid pint's volume of 28.875 cubic inches (473 ml) and the imperial pint of 34.68 cubic inches (568 ...
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output.
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...