Search results
Results from the WOW.Com Content Network
Entitled ‘Rules and Regulations for the prevention of Fire Risks Arising from Electric Lighting’, and known as the "Wiring Rules". Two core cable, line and neutral, no earth. Protection was a re-wirable fuse. 1888: 2nd: IEE: Entitled 'Wiring Rules & Regulations in Buildings. [verification needed] 1897: 3rd: IEE
A distribution board (also known as panelboard, circuit breaker panel, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure.
The cabling is installed as part of the data cabling as per detailed in this article in the section titled "Data Network Cabling". In addition to a cable being installed to every major appliance you also need to install a data cable near the electricity meter.
Special wiring rules apply to wet or corrosive locations, [13] and to locations which present an explosion hazard. [14] Wiring materials for use in the United States must generally be made and tested to product standards set by NEMA and Underwriters Laboratories (UL) and must bear approval marks such as those set by UL.
The front panel data port (FPDP) is a bus that provides high speed data transfer between two or more VMEbus boards at up to 160 Mbit/s with low latency. The FPDP bus uses a 32-bit parallel synchronous bus wired with an 80-conductor ribbon cable. [1] The following interface functions are supported: [2]
Structured cabling design and installation is governed by a set of standards that specify wiring data centers, offices, and apartment buildings for data or voice communications using various kinds of cable, most commonly Category 5e (Cat 5e), Category 6 (Cat 6), and fiber-optic cabling and modular connectors.
IEC 61554 Panel-Mounted equipment – Electrical measuring instruments – Dimensions for panel mounting IEC 61557 Electrical safety in low voltage distribution systems up to 1 000 V a.c. and 1 500 V d.c. – Equipment for testing, measuring or monitoring of protective measures
7.2 Equipment intended for fixed installation with internal connections to the data link Fixed installation products with internal connections to the data link may use the 5-pin XLR connector, but shall not use any other XLR connector. When use is made of the 5-pin XLR connector, the requirements of 7.1 and 7.1.1 shall apply.