Search results
Results from the WOW.Com Content Network
Control character. In computing and telecommunications, a control character or non-printing character (NPC) is a code point in a character set that does not represent a written character or symbol. They are used as in-band signaling to cause effects other than the addition of a symbol to the text.
ASCII (/ ˈæskiː / ⓘ ASS-kee), [3]: 6 an acronym for American Standard Code for Information Interchange, is a character encoding standard for electronic communication. ASCII codes represent text in computers, telecommunications equipment, and other devices.
In the narrowest sense, a control code is a character with the general category Cc, which comprises the C0 and C1 control codes, a concept defined in ISO/IEC 2022 and inherited by Unicode, with the most common set being defined in ISO/IEC 6429. Control codes are handled distinctly from ordinary Unicode characters, for example, by not being ...
C0 and C1 control codes. The C0 and C1 control code or control character sets define control codes for use in text by computer systems that use ASCII and derivatives of ASCII. The codes represent additional information about the text, such as the position of a cursor, an instruction to start a new line, or a message that the text has been ...
The table at C0 and C1 control codes § C0 controls shows the ASCII control characters, with the "Caret notation" column showing a caret (^), followed by the character to press while the Control key is held down to generate the character. If a teletypewriter or terminal is connected to a computer, the software on the computer can interpret ...
1 Control-C has typically been used as a "break" or "interrupt" key. 2 Control-D has been used to signal "end of file" for text typed in at the terminal on Unix / Linux systems. Windows, DOS, and older minicomputers used Control-Z for this purpose. 3 Control-G is an artifact of the days when teletypes were in use. Important messages could be ...
The Basic Latin Unicode block, [3] sometimes informally called C0 Controls and Basic Latin, [4] is the first block of the Unicode standard, and the only block which is encoded in one byte in UTF-8. The block contains all the letters and control codes of the ASCII encoding. It ranges from U+0000 to U+007F, contains 128 characters and includes ...
In the ASCII standard, the numbers 0-31 and 127 are assigned to control characters, for instance, code point 7 is typed by Ctrl+G. While some (most?) applications would insert a bullet character • (code point 7 on code page 437), some would treat this identical to Ctrl+G which often was a command for the program. [citation needed]