Search results
Results from the WOW.Com Content Network
The Attachment Unit Interface (AUI) is a physical and logical interface defined in the IEEE 802.3 standard for 10BASE5 Ethernet [1] and the earlier DIX standard. The physical interface consists of a 15-pin D-subminiature connector that links an Ethernet node's physical signaling to the Medium Attachment Unit (MAU), [ 2 ] sometimes referred to ...
Reduced Pin eXtended Attachment Unit Interface (RXAUI) is a proprietary modification created by Marvell [2] and Dune Networks [3] (later acquired by Broadcom [4]) aimed to increase the port density by decreasing the interface pin count. The four lanes of the standard XAUI running at 3.125 Gbit/s are replaced by two lanes at 6.25 Gbit/s.
AAUI signals have the same description, function, and electrical requirements as the Attachment Unit Interface (AUI) signals of the same name, as detailed in IEEE 802.3-1990 CSMA/CD Standard, section 7, [4] with the exception that most hosts provide only 5 volts of power rather than the 12 volts required for most AUI transceivers.
An Ethernet network interface controller (NIC) may include the 10BASE2 transceivers and thus directly provide a 10BASE2 BNC connector (that the T-connector plugs into), or it may offer an AUI connector that external transceivers (see Medium Attachment Unit) can connect to. These can be transceivers for 10BASE2, but also for 10BASE5 or 10BASE-T.
Originally in the 1980s Ethernet network interface cards or devices were connected using Attachment Unit Interface (AUI) cables to Medium Attachment Units that then connected to 10BASE5 and later 10BASE2 or 10BASE-T network cabling. The AUI cables used DA-15 connectors albeit with a sliding latch to lock the connectors together instead of the ...
A Medium Attachment Unit (MAU) is a transceiver which converts signals on an Ethernet cable to and from Attachment Unit Interface (AUI) signals. On original 10BASE5 (thicknet) Ethernet equipment, the MAU was typically clamped to the Ethernet wire via a vampire tap and connected by a multi-wire cable to the computer via a DA-15 port, which was ...
The vampire tap usually had an integrated AUI (Attachment Unit Interface) in the form of a DA-15 connector, from which a short multicore cable connected to the network card in the station (host computer). Vampire taps allowed new connections to be made on a given physical cable while the cable was in use.
Ethernet II frame, or Ethernet Version 2, [g] or DIX frame is the most common type in use today, as it is often used directly by the Internet Protocol. Novell raw IEEE 802.3 non-standard variation frame; IEEE 802.2 Logical Link Control (LLC) frame; IEEE 802.2 Subnetwork Access Protocol (SNAP) frame