Search results
Results from the WOW.Com Content Network
Aircraft flight mechanics are relevant to fixed wing (gliders, aeroplanes) and rotary wing (helicopters) aircraft. An aeroplane ( airplane in US usage), is defined in ICAO Document 9110 as, "a power-driven heavier than air aircraft, deriving its lift chiefly from aerodynamic reactions on surface which remain fixed under given conditions of flight".
A fixed-wing aircraft propulsion system generates forward thrust when air is pushed in the direction opposite to flight. This can be done by different means such as the spinning blades of a propeller, the propelling jet of a jet engine, or by ejecting hot gases from a rocket engine. [4]
The thrust-to-weight ratio varies continually during a flight. Thrust varies with throttle setting, airspeed, altitude, air temperature, etc. Weight varies with fuel burn and payload changes. For aircraft, the quoted thrust-to-weight ratio is often the maximum static thrust at sea level divided by the maximum takeoff weight. [2]
A takeoff/go-around switch (TO/GA; / ˈ t oʊ ɡ ə /) is a switch on the autothrottle of modern large aircraft, with two modes: takeoff (TO) and go-around (GA). The mode is dependent on the phase of flight; usually, on approach to land, the autopilot will be set to approach mode, therefore if the TO/GA switch is pressed it will activate the go-around mode of the autothrottle (about 90–92% ...
The thrust force from a stationary engine becomes thrust power when an aircraft is moving under its influence. Zhemchuzhin et al. [27] show an energy balance for a turbojet engine in flight in the form of a Sankey diagram. Component losses leave the engine as waste heat and add to the heat rejected area on a T~s diagram reducing the work area ...
Aircraft engine performance refers to factors including thrust or shaft power for fuel consumed, weight, cost, outside dimensions and life. It includes meeting regulated environmental limits which apply to emissions of noise and chemical pollutants, and regulated safety aspects which require a design that can safely tolerate environmental hazards such as birds, rain, hail and icing conditions.
Thrust levers of an A320 set to the autothrust position during cruise flight. An autothrottle (automatic throttle, also known as autothrust, A/T or A/THR) is a system that allows a pilot to control the power setting of an aircraft's engines by specifying a desired flight characteristic, rather than manually controlling the fuel flow.
Flex temp is a technique used to produce cost savings through increased engine life and reduced overhaul and fuel costs [1] for airliners by allowing them to take-off at less than rated thrust. [ 2 ] For Airbus and Fokker aircraft the technique is known as flex temp or just flex .