enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Indicator (distance amplifying instrument) - Wikipedia

   en.wikipedia.org/wiki/Indicator_(distance...

   Dial indicators typically measure ranges from 0.25 mm to 300 mm (0.015in to 12.0in), with graduations of 0.001 mm to 0.01 mm or 0.00005in to 0.001in (imperial/customary). Various names are used for indicators of different types and purposes, including dial gauge , clock , probe indicator , pointer , test indicator , dial test indicator , drop ...

3. Total indicator reading - Wikipedia

   en.wikipedia.org/wiki/Total_indicator_reading

   The indicator traditionally would be a dial indicator; today dial-type and digital indicators coexist. The earliest expansion of "TIR" was total indicated run-out and concerned cylindrical or tapered (conical) parts, where " run-out " (noun) refers to any imperfection of form that causes a rotating part such as a shaft to "run out" (verb), that ...

4. Lapping - Wikipedia

   en.wikipedia.org/wiki/Lapping

   The easiest method for measuring flatness is with a height gauge positioned on a surface plate. You must set up the part on three stands and find the minimum variation while adjusting them, just placing the part on the surface plate and using a dial indicator to find TIR on the opposite side of the part measures parallelism. Flatness is more ...

5. Gauge (instrument) - Wikipedia

   en.wikipedia.org/wiki/Gauge_(instrument)

   Dial indicator, also known as a dial test indicator, dial gauge, or probe indicator an instrument used to accurately measure small linear distances. Feeler gauge: a simple tool used to measure gap widths. Gauge block, (also known as a gage block, Johansson gauge, slip gauge, or Jo block) a precision ground and lapped length

6. Surface plate - Wikipedia

   en.wikipedia.org/wiki/Surface_plate

   Granite surface plate calibration should be performed routinely to maintain proper flatness and ensure measurement accuracy over time. The intervals between calibrations depends on the environment where the surface plate is located. When needed, lapping or resurfacing is provided to bring measurements within grade guidelines.

7. Gauge block - Wikipedia

   en.wikipedia.org/wiki/Gauge_block

   There is a formal test to measure wringability. First, the block is prepared for wringing using the standard process. The block is then slid across a 2 in (51 mm) reference grade (1 μin (0.025 μm) flatness) quartz optical flat while applying moderate pressure. Then, the bottom of the gauge block is observed (through the optical flat) for oil ...