Search results
Results from the WOW.Com Content Network
A level control valve or altitude control valve is a type of valve that automatically responds to changes in the height of a liquid in some storage system. A common example is the set of ballcocks in a flush toilet , where each stage of the flush cycle is actuated by the emptying or filling of the tank.
A control valve is a valve used to control fluid flow by varying the size of the flow passage as directed by a signal from a controller. [1] This enables the direct control of flow rate and the consequential control of process quantities such as pressure , temperature , and liquid level.
Traditional control valves make it inevitable. As we size a control valve, the K v calculated almost certainly will not match the K v of the nearest appropriate valve. For example, a K v calculation of 4.5 m 3 /h would most likely lead to the selection of a valve with a K v = 6.3 m 3 /h. This means the valve is capable of delivering 40% more ...
The four-way valve or four-way cock is a fluid control valve whose body has four ports equally spaced round the valve chamber and the plug has two passages to connect adjacent ports. The plug may be cylindrical or tapered, or a ball.
Leakage in narrow clearance, spool valve. Hydraulic clearance. Flow in narrow clearances are of vital importance in hydraulic system component design. The flow in a narrow circular clearance of a spool valve can be calculated according to the formula below if the height is negligible compared to the width of the clearance, such as most of the clearances in hydraulic pumps, hydraulic motors ...
The first primitive Christmas tree was used by the Hamill Brothers to bring Spindletop under control. It consisted of a T-valve, with a 6-inch (150 mm) and 8-inch (200 mm) valve on the vertical pipe, and a 6-inch valve on the horizontal pipe. The vertical valve was closed first, and then the valve to the horizontal pipe. [1] [2]
Leslie was purchased in 1989 by Watts Industries, Inc. of Andover, Massachusetts, which made water valves and was trying to increase its share of the valve industry. Leslie's 1988 sales were $33 million, Watts had sales of $181 million. [13] Leslie bought K&M Valve Company in 1995. [14]
Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size. The same connection method is used for a ballcock. The term tap is widely used to describe the valve used to dispense draft beer from a keg, whether gravity feed or ...