Search results
Results from the WOW.Com Content Network
Laurell Technologies WS-400 spin coater used to apply photoresist to the surface of a silicon wafer. Spin coating is a procedure used to deposit uniform thin films onto flat substrates. Usually a small amount of coating material in liquid form is applied on the center of the substrate, which is either spinning at low speed or not spinning at all.
There are four basic parameters that are involved in spin coating: solution viscosity, solid content (density), angular speed, and spin time. [13] A range of thicknesses can be achieved by spin coating. Most commonly the thicknesses range from 1-200 μm. The main properties that affect the thickness of the film are viscosity and spin speed.
A familiar example is the household mirror, which typically has a thin metal coating on the back of a sheet of glass to form a reflective interface. The process of silvering was once commonly used to produce mirrors, while more recently the metal layer is deposited using techniques such as sputtering .
For example, a whole car has been coated with spray assembly, optically transparent films have been prepared with spin assembly, etc. [1] Characterization of LbL film deposition is typically done by optical techniques such as dual polarisation interferometry or ellipsometry or mechanical techniques such as quartz crystal microbalance. [citation ...
Mask preparation with the Langmuir-Blodgett method has been demonstrated for example using SiO 2 particles [7] and polystyrene particles. [8] Dip-coating is a simplified version of the Langmuir-Blodgett. In dip coating, the nanosphere packing density isn't controlled but the dipping is performed directly on a colloidal particle solution.
Slot-die coating is a non-contact coating method, in which the slot-die is typically held over the substrate at a height several times higher than the target wet film thickness. [23] The coating fluid transfers from the slot-die to the substrate via a fluid bridge that spans the air gap between the slot-die lips and substrate surface.
Josh Brolin is reflecting on a candid interaction he had with Barbra Streisand about his drinking.. In an interview published on Saturday, Nov. 16, with The Times to promote his upcoming memoir ...
A BARC coating (Bottom Anti-Reflectant Coating) may be applied before the photoresist is applied, to avoid reflections from occurring under the photoresist and to improve the photoresist's performance at smaller semiconductor nodes such as 45 nm and below. [25] [26] [27] Top Anti-Reflectant Coatings (TARCs) also exist. [28]