enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   An assortment of screws, and a US quarter for size comparison A wood screw: a) head; b) non-threaded shank; c) threaded shank; d) tip The six classical simple machines. A screw is an externally helical threaded fastener capable of being tightened or released by a twisting force to the head.

3. Countersink - Wikipedia

   en.wikipedia.org/wiki/Countersink

   Countersink cutters are manufactured with six common angles, which are 60°, 82°, 90°, 100°, 110°, or 120°, with the two most common of those being 82° and 90°. Countersunk-head screws that follow the Unified Thread Standard very often have an 82° angle, and screws that follow the ISO standard very often have a 90° angle. Throughout ...

4. Preferred metric sizes - Wikipedia

   en.wikipedia.org/wiki/Preferred_metric_sizes

   Machine screws with different thread diameters Hex key set with metric sizes from 2 mm to 10 mm according to sizes for use with ISO 262 screw sizes (except 3.5 mm for M6 internal set screw) For each size bolt or screw and type of head, there is a corresponding size driver prescribed by various ISO standards, including:

5. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...

6. List of DIN standards - Wikipedia

   en.wikipedia.org/wiki/List_of_DIN_standards

   Slotted countersunk head screws (with countersunk heads as specified in ISO 2009-1972) Withdrawn: DIN EN ISO 2009: ISO 2009: DIN 964: Slotted raised countersunk oval head screws: Withdrawn: DIN EN ISO 2010: ISO 2010: DIN 965: Cross recessed countersunk flat head screws: Withdrawn: DIN EN ISO 7046-1, DIN EN ISO 7046-2: ISO 7046-1, ISO 7046-2 ...

7. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...