enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. J-B Weld - Wikipedia

   en.wikipedia.org/wiki/J-B_Weld

   The mixture sets in 4-6 hours and fully cures in up to 15 hours. It can be used as an adhesive, laminate, plug, filler, sealant, or electrical insulator and can be drilled, ground, tapped, machined, sanded, and painted when cured. J-B Kwik is a faster-curing two-part epoxy with medium-temperature resistance up to 300 °F (149 °C).

3. Epoxy - Wikipedia

   en.wikipedia.org/wiki/Epoxy

   Two part epoxy coatings were developed for heavy duty service on metal substrates and use less energy than heat-cured powder coatings. These systems provide a tough, protective coating with excellent hardness. One part epoxy coatings are formulated as an emulsion in water, and can be cleaned up without solvents.

4. Fusion bonded epoxy coating - Wikipedia

   en.wikipedia.org/wiki/Fusion_bonded_epoxy_coating

   The resin and hardener part together is known as the "Binder". As the name indicates, in Fusion bonded epoxy coatings the resin part is an "epoxy" type resin. “Epoxy” or “Oxirane” structure contains a three membered cyclic ring — one oxygen atom connected to two carbon atoms – in the resin molecule. This part is the most reactive ...

5. Epoxy putty - Wikipedia

   en.wikipedia.org/wiki/Epoxy_putty

   The left component is Epoxy Base Resin and the right one is Epoxy Hardener. Both are to be mixed thoroughly in equal quantity to get epoxy putty. Epoxy putty refers to a group of room-temperature-hardening substances used as space-filling adhesives. Exact compositions vary according to manufacturer and application.

6. Wood glue - Wikipedia

   en.wikipedia.org/wiki/Wood_glue

   Epoxy resin, usually as a two-part mix system, cures under a wider range of temperatures and moisture content than other glues, does not require pressure while curing, and has good gap-filling properties: near-perfect joints with very small gaps actually produce weaker bonds. Use of epoxy requires careful attention to the mixing ratio of the ...

7. Bondo (putty) - Wikipedia

   en.wikipedia.org/wiki/Bondo_(putty)

   These early fillers were epoxy-based and one-part, drying by outgassing. Originally, the plastic fillers performed badly compared to solder, but later improvements addressed this. [7] Bondo, a two-part mix (resin with hardener added) of talc and plastic, was introduced in 1955. [7]