Search results
Results from the WOW.Com Content Network
The actuator consists of a linear servo actuator servomotor that controls a plunger which varies air flow through the throttle body. The position of the servomotor and hence the amount of air bypass is controlled digitally by the engine ECU. This allows the engine's idle speed to be maintained constant.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
In fuel injected engines, the throttle body is the part of the air intake system that controls the amount of air flowing into the engine, in response to driver accelerator pedal input in the main. The throttle body is usually located between the air filter box and the intake manifold, and it is usually attached to, or near, the mass airflow sensor.
The first method is to use a throttle air bypass; this may be an external bypass valve or a solenoid valve which opens the throttle 12-20 degrees. This allows air to bypass the closed throttle and to reach the engine. The second method is to use a bypass valve that feeds charge air directly to the exhaust manifold.
A blowoff valve is designed to release pressure in the intake system when the throttle is closed. A "recirculating" type blowoff valve releases the pressurised air back into the non-pressurized section of the intake (i.e. upstream of the turbocharger), while an "atmospheric venting" type blowoff valve dumps the air directly into the atmosphere.
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
But 10 weeks postpartum, I began to notice I was entirely detached from my body. I did not want others to see me. I shied away from photos with my son. Every limb and piece of flesh felt separate ...
The system uses tubes with poppet valves from a central injector to spray fuel at each intake port rather than the central throttle body [citation needed]. Fuel pressure is similar to a single-point injection system. CPFI (used from 1992 to 1995) is a batch-fire system, while CSFI (from 1996) is a sequential system. [9]