enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Reflow soldering - Wikipedia

   en.wikipedia.org/wiki/Reflow_soldering

   Reflow soldering with long industrial convection ovens is the preferred method of soldering surface mount technology (SMT) components to a printed circuit board (PCB). Each segment of the oven has a regulated temperature, according to the specific thermal requirements of each assembly.

3. Reflow oven - Wikipedia

   en.wikipedia.org/wiki/Reflow_oven

   A convection reflow oven. A reflow oven is a machine used primarily for reflow soldering of surface mount electronic components to printed circuit boards (PCBs). In commercial high-volume use, reflow ovens take the form of a long tunnel containing a conveyor belt along which PCBs travel. For prototyping or hobbyist use PCBs can be placed in a ...

4. Rework (electronics) - Wikipedia

   en.wikipedia.org/wiki/Rework_(electronics)

   Reflowing as a rework technique, similar to the manufacturing process of reflow soldering, involves dismantling the equipment to remove the faulty circuit board, pre-heating the whole board in an oven, heating the non-functioning component further to melt the solder, then cooling, following a carefully determined thermal profile, and ...

5. Surface-mount technology - Wikipedia

   en.wikipedia.org/wiki/Surface-mount_technology

   If the circuit board is double-sided then this printing, placement, reflow process may be repeated using either solder paste or glue to hold the components in place. If a wave soldering process is used, then the parts must be glued to the board before processing to prevent them from floating off when the solder paste holding them in place is ...

6. Solder paste - Wikipedia

   en.wikipedia.org/wiki/Solder_paste

   Solder paste is used in the manufacture of printed circuit boards to connect surface mount components to pads on the board. It is also possible to solder through-hole pin in paste components by printing solder paste in and over the holes. The sticky paste temporarily holds components in place; the board is then heated, melting the paste and ...

7. Selective soldering - Wikipedia

   en.wikipedia.org/wiki/Selective_soldering

   Sensors installed to a fixture to check selective solder machine parameters Selective soldering machine. Selective soldering is the process of selectively soldering components to printed circuit boards and molded modules that could be damaged by the heat of a reflow oven or wave soldering in a traditional surface-mount technology (SMT) or through-hole technology assembly processes.