Search results
Results from the WOW.Com Content Network
The LM386 is an integrated circuit containing a low-voltage audio power amplifier. [1] It is suitable for battery-powered devices such as radios, guitar amplifiers, and hobby electronics projects. The IC consists of an 8-pin dual in-line package ( DIP-8 ) and can output 0.25 to 1 watts of power, depending on the model, using a 9-volt power supply.
The 5150 was based on the Soldano SLO-100 which Eddie Van Halen was using at the time and designed to provide high gain saturation as well as a clean channel. [5]While the product was designed around a centered printed circuit board (PCB), its cascading five preamps (actually four preamplifiers and one phase inverter) and four gain stages were implemented in a very simple manner.
Power op-amp with a maximal current output of 3 amperes [23] LM709 Yes General-purpose op-amp [24] LM741 LM709 General-purpose op-amp. [25] Widely used. LM747: Yes General-purpose dual op-amp. [26] LM748 General-purpose op-amp with external compensation [27] LM833 Dual high-speed audio operational amplifiers [28] LM837 Low-noise quadruple op ...
In this circuit, the base terminal of the transistor serves as the input, the collector is the output, and the emitter is common to both (for example, it may be tied to ground reference or a power supply rail), hence its name. The analogous FET circuit is the common-source amplifier, and the analogous tube circuit is the common-cathode amplifier.
Temperature-compensated log amplifiers may include more than one opamp and use closely-matched circuit elements to cancel out temperature dependencies. Integrated circuit (IC) log amplifiers have better bandwidth and noise performance and require fewer components and printed circuit board area than circuits built from discrete components.
Because the diode is a one-port (two terminal) device, an amplifier circuit must separate the outgoing amplified signal from the incoming input signal to prevent coupling. One common circuit is a reflection amplifier that separates the signals using a circulator. A bias tee is needed to isolate the bias current from the high-frequency oscillations.
The text below is intended to explain the use of the 76477 in the demo circuit shown at the right. SW1 is a five position rotary switch that selects which capacitor controls the one-shot circuit that sets the envelope timing. SW24 (toggle or momentary) is the one-shot trigger switch, closed position is active.
Using these conventions, in a common-emitter amplifier, the ratio v c /v b represents the small-signal voltage gain at the transistor, and v c /i b the small-signal trans-resistance, from which the name transistor is derived by contraction. In this convention, v i and v o usually refer to the external input and output voltages of the circuit or ...