enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Useful conversions and formulas for air dispersion modeling

    en.wikipedia.org/wiki/Useful_conversions_and...

    Pollution regulations in the United States typically reference their pollutant limits to an ambient temperature of 20 to 25 °C as noted above. In most other nations, the reference ambient temperature for pollutant limits may be 0 °C or other values. 1 percent by volume = 10,000 ppmv (i.e., parts per million by volume).

  3. Cancer slope factor - Wikipedia

    en.wikipedia.org/wiki/Cancer_slope_factor

    C = Concentration of the chemical in the contaminated environmental medium (soil or water) to which the person is exposed. The units are mg/kg for soil and mg/L for water. IR i = Intake rate of the contaminated environmental medium for age bin "i". The units are kg/day for soil and L/day for water. BW i = Body weight of the exposed person for ...

  4. Population equivalent - Wikipedia

    en.wikipedia.org/wiki/Population_equivalent

    Population equivalent (PE) or unit per capita loading, or equivalent person (EP), is a parameter for characterizing industrial wastewaters.It essentially compares the polluting potential of an industry (in terms of biodegradable organic matter) with a population (or certain number of people), which would produce the same polluting load.

  5. Air pollutant concentrations - Wikipedia

    en.wikipedia.org/wiki/Air_pollutant_concentrations

    The conversion equations depend on the temperature at which the conversion is wanted (usually about 20 to 25 °C). At an ambient sea level atmospheric pressure of 1 atm (101.325 kPa or 1.01325 bar ), the general equation is:

  6. Total dissolved solids - Wikipedia

    en.wikipedia.org/wiki/Total_dissolved_solids

    where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]

  7. Mixed liquor suspended solids - Wikipedia

    en.wikipedia.org/wiki/Mixed_liquor_suspended_solids

    The units MLSS is primarily measured in milligram per litre (mg/L), but for activated sludge its mostly measured in gram per litre [g/L] which is equal to kilogram per cubic metre [kg/m3]. Mixed liquor is a combination of raw or unsettled wastewater or pre-settled wastewater and activated sludge within an aeration tank.

  8. Equivalent (chemistry) - Wikipedia

    en.wikipedia.org/wiki/Equivalent_(chemistry)

    C 6 H 7 K 3 O 8: 324.41 g/mol 3 (K +) Liquid potassium citrate/gluconate therapy for adults and teenagers taken two to four times a day [3] 20 mEq potassium 20*324/3=2160 mg Potassium gluconate (anhydrous) C 6 H 11 KO 7: 234.245 g/mol 1 (K +) Liquid potassium citrate/gluconate therapy for adults and teenagers taken two to four times a day [3 ...

  9. Mass flux - Wikipedia

    en.wikipedia.org/wiki/Mass_flux

    Mathematically, mass flux is defined as the limit =, where = = is the mass current (flow of mass m per unit time t) and A is the area through which the mass flows.. For mass flux as a vector j m, the surface integral of it over a surface S, followed by an integral over the time duration t 1 to t 2, gives the total amount of mass flowing through the surface in that time (t 2 − t 1): = ^.