enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Ammonia (data page) - Wikipedia

    en.wikipedia.org/wiki/Ammonia_(data_page)

    The table above gives properties of the vapor–liquid equilibrium of anhydrous ammonia at various temperatures. The second column is vapor pressure in kPa. The third column is the density of the liquid phase. The fourth column is the density of the vapor. The fifth column is the heat of vaporization needed to convert one gram of liquid to vapor.

  3. Process flow diagram - Wikipedia

    en.wikipedia.org/wiki/Process_flow_diagram

    A process flow diagram (PFD) is a diagram commonly used in chemical and process engineering to indicate the general flow of plant processes and equipment. The PFD displays the relationship between major equipment of a plant facility and does not show minor details such as piping details and designations.

  4. Modeling and simulation of batch distillation unit - Wikipedia

    en.wikipedia.org/wiki/Modeling_and_simulation_of...

    The distribution of the component in the two phase is governed by the vapour-liquid equilibrium relationship. In practice, distillation may be carried out by either two principal methods. The first method is based on the production of vapor boiling the liquid mixture to be separated and condensing the vapors without allowing any liquid to ...

  5. Ammonia - Wikipedia

    en.wikipedia.org/wiki/Ammonia

    Liquid ammonia has a very high standard enthalpy change of vapourization (23.5 kJ/mol; [28] for comparison, water's is 40.65 kJ/mol, methane 8.19 kJ/mol and phosphine 14.6 kJ/mol) and can be transported in pressurized or refrigerated vessels; however, at standard temperature and pressure liquid anhydrous ammonia will vaporize. [29]

  6. Trickle-bed reactor - Wikipedia

    en.wikipedia.org/wiki/Trickle-bed_reactor

    A trickle-bed reactor (TBR) is a chemical reactor that uses the downward movement of a liquid and the downward (co-current) or upward (counter-current) movement of gas over a packed bed of particles. It is considered to be the simplest reactor type for performing catalytic reactions where a gas and liquid (normally both reagents) are present in ...

  7. Flash evaporation - Wikipedia

    en.wikipedia.org/wiki/Flash_evaporation

    If the saturated liquid is a single-component liquid (for example, propane or liquid ammonia), a part of the liquid immediately "flashes" into vapor. Both the vapor and the residual liquid are cooled to the saturation temperature of the liquid at the reduced pressure.

  8. Phase diagram - Wikipedia

    en.wikipedia.org/wiki/Phase_diagram

    A tie line from the liquid to the gas at constant pressure would indicate the two compositions of the liquid and gas respectively. [14] A simple example diagram with hypothetical components 1 and 2 in a non-azeotropic mixture is shown at right. The fact that there are two separate curved lines joining the boiling points of the pure components ...

  9. Liquefaction of gases - Wikipedia

    en.wikipedia.org/wiki/Liquefaction_of_gases

    Many gases can be put into a liquid state at normal atmospheric pressure by simple cooling; a few, such as carbon dioxide, require pressurization as well. Liquefaction is used for analyzing the fundamental properties of gas molecules (intermolecular forces), or for the storage of gases, for example: LPG, and in refrigeration and air conditioning.