Search results
Results from the WOW.Com Content Network
[1] In 1933, Chief Engineer Howard Manning developed the tongue-and-groove, slip-joint pliers for which the company is known. In 1934, a patent for this design [5] was granted, and in 1949, a trademark for the name "Channellock" was granted, with a first-use date of May 1, 1932. [6]
A strong joint, the tongue and groove joint is widely used for re-entrant angles. The effect of wood shrinkage is concealed when the joint is beaded or otherwise moulded. [ 1 ] In expensive cabinet work, glued dovetail and multiple tongue and groove are used.
A through [1] dado involves cuts which run between both edges of the surface, leaving both ends open. A stopped or blind [2] dado ends before one (stopped) or both (blind) of the cuts meets the edge of the surface. [1] A half dado is formed with a narrow dado cut into one part, coupled with a rabbet of another piece. This joint tends to be used ...
1.5: 17 × 50 More common as a NiCd or NiMH cell size than a primary size, popular in older laptop batteries and hobby battery packs. Various fractional sizes are also available; e.g., 2 ⁄ 3 A and 4 ⁄ 5 A. B: U10 336 (Russian Federation) #3 (China) R12 (carbon‑zinc) LR12 (alkaline) 8,350 (alkaline) 1.5: 21.5 × 60
A through groove (left) and a stopped groove. In joinery, a groove is a slot or trench cut into a member which runs parallel to the grain. A groove is thus differentiated from a dado, which runs across the grain. [1] Grooves are used for a range of purposes in cabinet making and other woodworking fields.
This canal can be round, oval or an arc in order to receive another component such as a boss, a tongue or a gasket. It can also be on the circumference of a dowel, a bolt, an axle or on the outside or inside of a tube or pipe etc. This canal may receive a circlip, an o-ring, or a gasket.
1. A short piece of a log, especially one used for fuel. 2. A split-out piece of a bolt of wood. blind Joinery with mating surfaces not protruding through the face or end grain of the pieces being joined. An example is a "blind" mortise and tenon joint. bolster. Also called a pillow or cross head. 1. A shoulder. 2.
A chamfer with a "lark's tongue" finish. A chamfer (/ ˈ ʃ æ m f ər / SHAM-fər or / ˈ tʃ æ m f ər / CHAM-fər) is a transitional edge between two faces of an object.Sometimes defined as a form of bevel, it is often created at a 45° angle between two adjoining right-angled faces.