enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Board-to-board connector - Wikipedia

   en.wikipedia.org/wiki/Board-to-board_connector

   Board-to-board (BTB) connectors are used to connect printed circuit boards (PCB), electronic components that contain a conductive pattern printed on the surface of the insulating base in an accurate and repeatable manner. Each terminal on a BTB connector is connected to a PCB. A BTB connector includes housing and a specific number of terminals.

3. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.

4. List of electronic component packaging types - Wikipedia

   en.wikipedia.org/wiki/List_of_electronic...

   Clearance between package body and PCB. H Height of package from pin tip to top of package. T Thickness of pin. L Length of package body only. L W Pin width. L L Pin length from package to pin tip. P Pin pitch (distance between conductors to the PCB). W B Width of the package body only. W L Length from pin tip to pin tip on the opposite side.

5. Printed circuit board - Wikipedia

   en.wikipedia.org/wiki/Printed_circuit_board

   Not to be confused with Printed electronics. "PCB" redirects here. For other uses, see PCB (disambiguation). "PC board" redirects here. For the mainboard of personal computers, see Motherboard. "Panelization" redirects here. For the page layout strategy, see N-up. Printed circuit board of a DVD player Part of a 1984 Sinclair ZX Spectrum computer board, a printed circuit board, showing the ...

6. Point-to-point construction - Wikipedia

   en.wikipedia.org/wiki/Point-to-point_construction

   Section of a typical Australian late 1930s radio, showing the point to point construction between components. In electronics, point-to-point construction is a non-automated technique for constructing circuits which was widely used before the use of printed circuit boards (PCBs) and automated assembly gradually became widespread following their introduction in the 1950s.

7. Breadboard - Wikipedia

   en.wikipedia.org/wiki/Breadboard

   Strips consist of interconnected electrical terminals. Often breadboard strips or blocks of one brand have male and female dovetail notches so boards can be clipped together to form a large breadboard. The main areas, to hold most of the electronic components, are called terminal strips. In the middle of a terminal strip of a breadboard, one ...