enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   Some 2-hole punches have an "888" marking on their paper guide, to assist punching all four holes into A4 paper. [ 5 ] Konica Minolta specifies that for European 4-hole arrangements, all holes should be 11 ± 1 mm from the nearest (i.e. long/spine) edge of the paper, [ 6 ] which is slightly at variance with ISO 838's specification of 12 ± 1 mm .

3. Paper drilling - Wikipedia

   en.wikipedia.org/wiki/Paper_drilling

   Paper-drilling machine. Paper drilling is a technique used in binderies for providing large quantities of paper with round holes. [1] The paper can be processed as loose leaves and in brochures (stitched, perfectly bound). [citation needed] The holes can be drilled for storage purposes, such as filing, [1] or sometimes for decorative purposes ...

4. Comb binding - Wikipedia

   en.wikipedia.org/wiki/Comb_binding

   To bind a document, the user first punches holes in the paper with a specialized hole punch. Pages must be punched a few at a time with most of these machines. If hard covers are desired, they must be punched as well. In bulk applications, a paper drilling machine may be used. Then the user chooses a spine size that will match the document.

5. Fun and Creative Gifts for Women Who Like Crafts

   www.aol.com/fun-creative-gifts-women-crafts...

   $13 from Amazon. Shop Now. For anyone looking to cash in on their crafts, this book is a must-have. It provides detailed information on how to best market and sell crafts online, including on ...

6. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   The punch force required to punch a piece of sheet metal can be estimated from the following equation: [4] F = 0.7 t L ( U T S ) {\displaystyle F=0.7tL(UTS)} Where t is the sheet metal thickness, L is the total length sheared (perimeter of the shape), and UTS is the ultimate tensile strength of the material.

7. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A center punch is used to mark the center of a point. It is usually used to mark the center of a hole when drilling holes. A drill has the tendency to "wander" if it does not start in a recess. A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1]