Search results
Results from the WOW.Com Content Network
YAGARTO – free GCC (no longer supported) [34] Code::Blocks (EPS edition) (debug with ST-LINK no GDB and no OpenOCD required) [35] IDE for Arduino ARM boards. Arduino [note 5] – IDE for Atmel SAM3X (Arduino Due) Energia – Arduino IDE for Texas Instruments Tiva and CC3200; Notes:
ChibiOS/RT is designed for embedded applications on microcontrollers of 8-, 16-, and 32-bits.Size and execution efficiency are the main project goals. [3] As reference, the kernel size can range from a minimum of 1.2 KiB up to a maximum of 5.5 KiB with all the subsystems activated on a STM32 Cortex-M3 processor.
The MSP430s can run up to 25 MHz, while register-to-register operations take 1 cycle per instruction. The MSP430 family has more than 550 types, [4] not counted package variants. There are microcontrollers with 0.5-512 kB flash or 0.5-256 kB FRAM and up to 66 kB RAM. The device comes in a variety of generations featuring the usual peripherals:
Devices communicate to the world via a set of input and output pins. By themselves, these pins provide limited visibility into the workings of the device. However, devices that support boundary scan contain a shift-register cell for each signal pin of the device. These registers are connected in a dedicated path around the device's boundary ...
OpenCL (Open Computing Language) is a framework for writing programs that execute across heterogeneous platforms consisting of central processing units (CPUs), graphics processing units (GPUs), digital signal processors (DSPs), field-programmable gate arrays (FPGAs) and other processors or hardware accelerators.
High-speed signals support devices up to 200 MHz and the latest eMMC HS400 modes with data transfer rates of 2.5 nanoseconds per byte. In the context of installing firmware onto a device, a programmer , device programmer , chip programmer , device burner , [ 1 ] : 364 or PROM writer [ 2 ] is a device that writes, a.k.a. burns, firmware to a ...
fwupd is an open-source daemon for managing the installation of firmware updates on Linux-based systems, developed by GNOME maintainer Richard Hughes. [1] It is designed primarily for servicing the Unified Extensible Firmware Interface (UEFI) firmware on supported devices via EFI System Resource Table (ESRT) and UEFI Capsule, which is supported in Linux kernel 4.2 and later.
Android x86 (ver. 4.0) on EeePC 701 4G. Android-x86 is an open source project that makes an unofficial porting of the Android mobile operating system developed by the Open Handset Alliance to run on devices powered by x86 processors, rather than RISC-based ARM chips.