enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Flare fitting - Wikipedia

   en.wikipedia.org/wiki/Flare_fitting

   The tool used to flare tubing consists of a die that grips the tube, and either a mandrel or rolling cone is forced into the end of the tube to form the flare by cold working. The most common flare fitting standards in use today are the 45° SAE flare [ 2 ] [ 3 ] ,the 37° JIC flare, and the 37° AN flare.

3. Cold working - Wikipedia

   en.wikipedia.org/wiki/Cold_working

   In metallurgy, cold forming or cold working is any metalworking process in which metal is shaped below its recrystallization temperature, usually at the ambient temperature.. Such processes are contrasted with hot working techniques like hot rolling, forging, welding, etc. [1]: p.375 The same or similar terms are used in glassmaking for the equivalents; for example cut glass is made by "cold ...

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Although they are usually used to attach pipe and fittings to mechanical supports in buildings, they do not connect the pipes. Fasteners commonly used with piping are a stud bolt [26] with nuts (usually fully threaded, with two heavy, hexagonal nuts); a machine bolt and nut; or a powder-actuated tool (PAT) fastener (usually a nail or threaded ...

5. Swaging - Wikipedia

   en.wikipedia.org/wiki/Swaging

   A finishing operation, shaping, cold works the points on the tooth sides to flats. It might be considered as a side swage. This slightly reduces the tooth width but increases the operating time between "fittings". Swaging is a major advance over filing as the operation is faster, more precise and greatly extends the working life of a saw.

6. Copper tubing - Wikipedia

   en.wikipedia.org/wiki/Copper_tubing

   While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 3 ⁄ 4 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...

7. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

8. Furniture screw - Wikipedia

   en.wikipedia.org/wiki/Furniture_screw

   A Chinese study published in 2019 which compared different types of screws used in medium density fiberboards (MDF) for furniture purposes found that the most important factor for how well a screw worked was the depth of the screw, and secondly the diameter of the hole. The screw type itself, however, had the least effect on the strength of the ...

9. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...