enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Medium-dependent interface - Wikipedia

   en.wikipedia.org/wiki/Medium-dependent_interface

   The terminology generally refers to variants of the Ethernet over twisted pair technology that use a female 8P8C port connection on a computer, or other network device.. The X refers to the fact that transmit wires on an MDI device must be connected to receive wires on an MDI-X device.

3. Router (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_(woodworking)

   The sole plate is then either rested flat on the workpiece overhanging the edge so that the cutting bit is not contacting the work (and then entering the work from the side once the motor is turned on), or the sole plate is placed at an angle with the bit above the work and the bit is "rocked" over into the work once the motor is turned on.

4. Attachment Unit Interface - Wikipedia

   en.wikipedia.org/wiki/Attachment_Unit_Interface

   An AUI connector is a DA-15 (D-subminiature) type, where the DTE side has a female connector and the MAU side has a male connector. [1]The connector often uses a sliding clip instead of the typical thumbscrews found on D-connectors, allowing the DTE and MAU to be directly attached, even when their size or shape would not accommodate thumbscrews.

5. Management Data Input/Output - Wikipedia

   en.wikipedia.org/wiki/Management_Data_Input/Output

   Before a register access, PHY devices generally require a preamble of 32 ones to be sent by the MAC on the MDIO line. The access consists of 16 control bits, followed by 16 data bits. The control bits consist of 2 start bits, 2 access type bits (read or write), the PHY address (5 bits), the register address (5 bits), and 2 "turnaround" bits.

6. Router table (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_table_(woodworking)

   Router tables are used in one of three ways. In all cases, an accessory is used to direct the workpiece. A fence is used, with the router bit partially emerging from the fence. The workpiece is then moved against the fence, and the exposed portion of the router bit removes material from the workpiece. No fence is used.

7. Costco's most expensive cruise sale this year was a $293K ...

   www.aol.com/news/costcos-most-expensive-cruise...

   Costco membership also gives shoppers access to the club's travel deals. The company revealed its largest booking in the last year was a 150-day cruise around the world.. CFO Gary Millerchip said ...