Search results
Results from the WOW.Com Content Network
Noise, static or snow screen captured from a VHS tape. Noise, commonly known as static, white noise, static noise, or snow, in analog video, CRTs and television, is a random dot pixel pattern of static displayed when no transmission signal is obtained by the antenna receiver of television sets and other display devices.
The AV-sync delay is static but can vary with the individual clip. Video editing effects can delay video causing it to lag the audio. Transmission (broadcasting), reception and playback that can get introduce AV-sync errors. A video camera with built-in microphones or line-in may not delay sound and video paths by the same amount.
Radio noise near in frequency to a received radio signal (in the receiver's passband) interferes (RFI) with the operation of the receiver's circuitry.The level of noise determines the maximum sensitivity and reception range of a radio receiver; if no noise were picked up with radio signals, even weak transmissions could be received at virtually any distance by making a radio receiver that had ...
Noise reduction techniques exist for audio and images. Noise reduction algorithms may distort the signal to some degree. Noise rejection is the ability of a circuit to isolate an undesired signal component from the desired signal component, as with common-mode rejection ratio.
Ground loops occur when there is a voltage difference between two ground connections. A good way to fix this is to bring all the ground wires to the same potential in a ground bus. Shielding cables – A shielded cable can be thought of as a Faraday cage for wiring and can protect the wires from unwanted noise in a sensitive circuit. The shield ...
A noise-cancellation speaker emits a sound wave with the same amplitude but with an inverted phase (also known as antiphase) relative to the original sound. The waves combine to form a new wave, in a process called interference , and effectively cancel each other out – an effect which is called destructive interference .
Sound masking is the inclusion of generated sound (commonly, though inaccurately, referred to as "white noise" or "pink noise") into an environment to mask unwanted sound. It relies on auditory masking. Sound masking is not a form of active noise control (noise cancellation technique); however, it can reduce or eliminate the perception of sound ...
A pair of headphones being tested inside an anechoic chamber for soundproofing. Soundproofing is any means of impeding sound propagation.There are several methods employed including increasing the distance between the source and receiver, decoupling, using noise barriers to reflect or absorb the energy of the sound waves, using damping structures such as sound baffles for absorption, or using ...