Search results
Results from the WOW.Com Content Network
Yet other definitions are in use for industrial gas, [5] where, in the US, a standard cubic foot for industrial gas use is defined at 70 °F (21.1 °C) and 14.696 psia (101.325 kPa), while in Canada, a standard cubic meter for industrial gas use is defined at 15 °C (59 °F) and 101.325 kPa (14.696 psia).
Oil conversion factor from m³ to bbl (or stb) is 6.28981100; Gas conversion factor from standard m³ to scf is 35.314666721; Note that the m³ gas conversion factor takes into account a difference in the standard temperature base for measurement of gas volumes in metric and imperial units.
This was the first such plant in the world. Originally it had three spheres, approximately 63 feet in diameter containing LNG at −260 °F. Each sphere held the equivalent of about 50 million cubic feet of natural gas. A fourth tank, a cylinder, was added in 1942. It had an equivalent capacity of 100 million cubic feet of gas.
Actual cubic feet per minute (ACFM) is a unit of volumetric flow. It is commonly used by manufacturers of blowers and compressors. [1] This is the actual gas delivery with reference to inlet conditions, whereas cubic foot per minute (CFM) is an unqualified term and should only be used in general and never accepted as a specific definition without explanation.
One GGE of natural gas is 126.67 cubic feet (3.587 m 3) at standard conditions. This volume of natural gas has the same energy content as one US gallon of gasoline (based on lower heating values: 900 BTU/cu ft (9.3 kWh/m 3) of natural gas and 114,000 BTU/US gal (8.8 kWh/L) for gasoline). [22]
The ideal gas equation can be rearranged to give an expression for the molar volume of an ideal gas: = = Hence, for a given temperature and pressure, the molar volume is the same for all ideal gases and is based on the gas constant: R = 8.314 462 618 153 24 m 3 ⋅Pa⋅K −1 ⋅mol −1, or about 8.205 736 608 095 96 × 10 −5 m 3 ⋅atm⋅K ...
The Chevrolet Equinox's only engine option is a 1.5-liter turbocharged four-cylinder that carries over from the previous generation. The motor, which produces 175 horsepower and 203 lb-ft of ...
In the SI system of units, the preferred unit for volumetric flow rate is cubic meter per second, equivalent to 60,000 liters per minute. If the gas is to be considered as an ideal gas, then SLPM can be expressed as mole per second using the molar gas constant = 8.314510 J⋅K −1 ⋅mol −1: = = mol/s.