Search results
Results from the WOW.Com Content Network
A typical timber shear wall consists of braced panels in the wall line, constructed using structural plywood sheathing, specific nailing at the edges, and supporting framing. A shear wall is an element of a structurally engineered system that is designed to resist in-plane lateral forces, typically wind and seismic loads.
Aircraft plywood is available in thicknesses of 1 ⁄ 8 inch (3 mm) (3-ply construction) and upwards; typically aircraft plywood uses veneers of 0.5 mm (approx 1/64 in) thickness although much thinner veneers such as 0.1 mm are also used in construction of some of the thinner panels.
A table is built pretty much the same way as a beam formwork but the single parts of this system are connected together in a way that makes them transportable. The most common sheathing is plywood, but steel and fiberglass are used. The joists are either made from timber, engineered lumber (often in the form of I-beams), aluminium or steel. The ...
The number of layers placed is determined partly by the thickness of the panel, but is limited by the equipment installed at the manufacturing site. Individual layers can also vary in thickness to give different finished panel thicknesses; typically, a 15 cm (5.9 in) layer will produce a 15 mm (0.59 in) panel thickness [citation needed]. The ...
The result is a tapered shingle sawn on all six sides. The thickness of the butt, or thicker end of the tapered cut, is usually 3 ⁄ 8 inch (9.5 mm) thick but is also commonly made to be 5 ⁄ 8 inch (16 mm), and can be made to any custom specifications.
While plywood became widespread by the early 20th century, the invention of LVL was not until the 1980s after the invention of oriented strand board. [3] The American Wood Council's National Design Specification for Wood Construction is generally updated on a 3- to 5-year cycle. The 1991 release is the first release which mentions LVL.
Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles.
A double floor is a floor framed with joists supported by larger timbers.. In traditional timber framing there may be a single set of joists which carry both a floor and ceiling called a single floor (single joist floor, single framed floor) or two sets of joists, one carrying the floor and another carrying the ceiling called a double floor (double framed floor).