Ads
related to: mti and pulse doppler radar ppt template powerpointaippt.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
Phase jitter, Doppler effects, and environmental influences limit MTI sub-clutter visibility Measure of Performance to about 25 dB improvement. This allows moving objects about 300 times smaller to be detected in close proximity to larger stationary objects. Pulse-Doppler signal processing is required to achieve greater sub-clutter visibility.
A pulse-Doppler radar is a radar system that determines the range to a target using pulse-timing techniques, and uses the Doppler effect of the returned signal to determine the target object's velocity.
Pulse-Doppler signal processing is a radar and CEUS performance enhancement strategy that allows small high-speed objects to be detected in close proximity to large slow moving objects. Detection improvements on the order of 1,000,000:1 are common.
For ground-based radar, cluttered returns tend to be at DC, making them easily discriminated by Moving Target Indication (MTI). [3] Thus, a notch filter at the zero-Doppler bin can be used. [2] Airborne platforms with ownship motion experience relative ground clutter motion dependent on the angle, resulting in angle-Doppler coupling at the ...
Radar Pulse Train. The carrier is an RF signal, typically of microwave frequencies, which is usually (but not always) modulated to allow the system to capture the required data. In simple ranging radars, the carrier will be pulse modulated and in continuous wave systems, such as Doppler radar, modulation may not be required
A Doppler radar is a specialized radar that uses the Doppler effect to produce velocity data about objects at a distance. [1] It does this by bouncing a microwave signal off a desired target and analyzing how the object's motion has altered the frequency of the returned signal.
Pulse-Doppler radar can reduce clutter by over 60 dB, which can allow objects smaller than 1-square-foot (0.093 m 2) to be detected without overloading computers and users. Systems using pulse-Doppler signal processing with speed rejection set above the wind speed have no clutter zone. This means that the clear region extends all the way to the ...
The AN/ZPQ-1 uses a radar signal in the 10 – 20 GHz J-band, and can work in strip map, spot map, and MTI modes. These modes are applicable to a wide range of MASINT sensors. Strip map imaging observes terrain parallel to the flight path or along a specified ground path. Resolution depends on range and swath width, and can vary from 0.3 to 1.0 ...
Ads
related to: mti and pulse doppler radar ppt template powerpointaippt.com has been visited by 10K+ users in the past month