Search results
Results from the WOW.Com Content Network
The solid–liquid phase boundary can only end in a critical point if the solid and liquid phases have the same symmetry group. [5] For most substances, the solid–liquid phase boundary (or fusion curve) in the phase diagram has a positive slope so that the melting point increases with pressure.
The solid line refers to the entropy of strontium in its normal standard state at 1 atm pressure. The dashed line refers to the entropy of strontium vapor in a non-physical state. The standard entropy change for the formation of a compound from the elements, or for any standard reaction is designated ΔS° form or ΔS° rx. The entropy change ...
Phase transitions commonly refer to when a substance transforms between one of the four states of matter to another. At the phase transition point for a substance, for instance the boiling point, the two phases involved - liquid and vapor, have identical free energies and therefore are equally likely to exist.
A saturation dome uses the projection of a P–v–T diagram (pressure, specific volume, and temperature) onto the P–v plane. The points that create the left-hand side of the dome represent the saturated liquid states, while the points on the right-hand side represent the saturated vapor states (commonly referred to as the “dry” region).
The upper curve is the line of liquidus, and the lower curve is the line of solidus. In chemistry , materials science , and physics , the liquidus temperature specifies the temperature above which a material is completely liquid, [ 2 ] and the maximum temperature at which crystals can co-exist with the melt in thermodynamic equilibrium .
A typical phase diagram for a single-component material, exhibiting solid, liquid and gaseous phases. The solid green line shows the usual shape of the liquid–solid phase line. The dotted green line shows the anomalous behavior of water when the pressure increases. The triple point and the critical point are shown as red dots.
David R. Lide (ed), CRC Handbook of Chemistry and Physics, 84th Edition.CRC Press. Boca Raton, Florida, 2003; Section 6, Fluid Properties; Vapor Pressure Uncertainties of several degrees should generally be assumed.
The saturated liquid curve is the curve separating the subcooled liquid state and the two-phase state in the T–s diagram. [1] When used in a power cycle, the fluid expansion depends strongly on the nature of this saturation curve: A "wet" fluid shows a negative saturation vapor curve. If overheating before the expansion is limited, a two ...