Search results
Results from the WOW.Com Content Network
The solid–liquid phase boundary can only end in a critical point if the solid and liquid phases have the same symmetry group. [5] For most substances, the solid–liquid phase boundary (or fusion curve) in the phase diagram has a positive slope so that the melting point increases with pressure.
The curve agrees completely with the numerical results referenced earlier. In the region inside the spinodal curve there are two states at each point, one stable and one metastable, either superheated liquid to the right of the blue curve, or subcooled vapor to the left, while outside the spinodal curve there is one stable state at each point.
The Clausius–Clapeyron equation [8]: 509 applies to vaporization of liquids where vapor follows ideal gas law using the ideal gas constant and liquid volume is neglected as being much smaller than vapor volume V. It is often used to calculate vapor pressure of a liquid. [9]
Vapor pressure of liquid and solid benzene. Equilibrium vapor pressure can be defined as the pressure reached when a condensed phase is in equilibrium with its own vapor. In the case of an equilibrium solid, such as a crystal, this can be defined as the pressure when the rate of sublimation of a solid matches the rate of deposition of its vapor ...
The commonly known phases solid, liquid and vapor are separated by phase boundaries, i.e. pressure–temperature combinations where two phases can coexist. At the triple point, all three phases can coexist. However, the liquid–vapor boundary terminates in an endpoint at some critical temperature T c and critical pressure p c. This is the ...
A saturation dome uses the projection of a P–v–T diagram (pressure, specific volume, and temperature) onto the P–v plane. The points that create the left-hand side of the dome represent the saturated liquid states, while the points on the right-hand side represent the saturated vapor states (commonly referred to as the “dry” region).
A typical phase diagram.The solid green line applies to most substances; the dashed green line gives the anomalous behavior of water. In thermodynamics, the triple point of a substance is the temperature and pressure at which the three phases (gas, liquid, and solid) of that substance coexist in thermodynamic equilibrium. [1]
The upper one, representing the mole fraction of the vapor at various temperatures, is called the dew point curve. [1] These two curves necessarily meet where the mixture becomes purely one component, namely where x 1 = 0 (and x 2 = 1, pure component 2) or x 1 = 1 (and x 2 = 0, pure component 1). The temperatures at those two points correspond ...