enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hard disk drive interface - Wikipedia

   en.wikipedia.org/wiki/Hard_disk_drive_interface

   Confusingly, drives usually use copper twisted-pair cables for Fibre Channel, not fibre optics. The latter are traditionally reserved for larger devices, such as servers or disk array controllers. An mSATA SSD on top of a 2.5-inch SATA drive. Serial ATA (SATA). The SATA data cable has one data pair for differential transmission of data to the ...

3. SATA - Wikipedia

   en.wikipedia.org/wiki/SATA

   A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...

4. List of disk drive form factors - Wikipedia

   en.wikipedia.org/wiki/List_of_disk_drive_form...

   Later, the micro-SATA interface made the total length 78.5mm. 1.8-inch drives with ZIF connectors were used in digital audio players, such as the iPod Classic, and subnotebooks. Later 1.8-inch drives were updated with a micro-SATA connector and up to 320GB of storage (Toshiba MK3233GSG).

5. U.2 - Wikipedia

   en.wikipedia.org/wiki/U.2

   U.3 (SFF-TA-1001) is built on the U.2 spec and uses the same SFF-8639 connector. A single "tri-mode" (PCIe/SATA/SAS) backplane receptacle can handle all three types of connections; the controller automatically detects the type of connection used. This is unlike U.2, where users need to use separate controllers for SATA/SAS and NVMe.

6. Hard disk drive - Wikipedia

   en.wikipedia.org/wiki/Hard_disk_drive

   Inner view of a 1998 Seagate HDD that used the Parallel ATA interface 2.5-inch SATA drive on top of 3.5-inch SATA drive, showing close-up of (7-pin) data and (15-pin) power connectors. Current hard drives connect to a computer over one of several bus types, including parallel ATA, Serial ATA, SCSI, Serial Attached SCSI (SAS), and Fibre Channel.

7. Solid-state drive - Wikipedia

   en.wikipedia.org/wiki/Solid-state_drive

   The SATADIMM from Viking Technology uses an empty DDR3 DIMM slot on the motherboard to provide power to the SSD with a separate SATA connector to provide the data connection back to the computer. The result is an easy-to-install SSD with a capacity equal to drives that typically take a full 2.5-inch drive bay. [104]

8. Parallel ATA - Wikipedia

   en.wikipedia.org/wiki/Parallel_ATA

   Parallel ATA (PATA), originally AT Attachment, also known as Integrated Drive Electronics (IDE), is a standard interface designed for IBM PC-compatible computers.It was first developed by Western Digital and Compaq in 1986 for compatible hard drives and CD or DVD drives.

9. SATA Express - Wikipedia

   en.wikipedia.org/wiki/SATA_Express

   The Serial ATA interface was designed primarily for interfacing with hard disk drives (HDDs), doubling its native speed with each major revision: maximum SATA transfer speeds went from 1.5 Gbit/s in SATA 1.0 (standardized in 2003), through 3 Gbit/s in SATA 2.0 (standardized in 2004), to 6 Gbit/s as provided by SATA 3.0 (standardized in 2009). [9]