Search results
Results from the WOW.Com Content Network
Braces are used to adjust the fore and aft angle of a yard (i.e. to rotate the yard laterally, fore and aft, around the mast). [2] Sheets attach to the clews (bottom corners) of a sail to control the sail's angle to the wind. Sheets run aft (for comparison, see tacks). [2]
Fore-and-aft rigs include: Rigs with one mast: the proa, the catboat, the sloop, the cutter; Rigs with two masts: the ketch, the yawl; Rigs with two or more masts: the schooner; Barques and barquentines are partially square rigged and partially fore-and-aft rigged. A rig which combines both on a foremast is known as a hermaphroditic rig.
Fore or forward: at or toward the front of a ship or further ahead of a location (opposite of "aft") [1] Preposition form is "before", e.g. "the mainmast is before the mizzenmast". Inboard: attached inside the ship. [14] Keel: the bottom structure of a ship's hull. [15] Leeward: side or direction away from the wind (opposite of "windward"). [16]
Fore-and-aft rigs comprise the vast majority of sailing vessels in use today, including effectively all dinghies and yachts. The sheet on a fore-and-aft sail controls the angle of the sail to the wind, and should be adjusted to keep the sail just filled. Most smaller boats use the Bermuda rig, which has two or three sets of sheets:
However, under sail on a given tack, the corner to which the spinnaker sheet is attached is called the clew, and the corner attached to the spinnaker pole is referred to as the tack. [20] Tack – The tack is the corner on a fore-and-aft sail where the luff and foot connect [8] and, on a mainsail, is located where the boom and mast connect.
Sail shape is usually controlled by lines that pull at the corners of the sail, including the outhaul at the clew and the downhaul at the tack on fore-and-aft rigs. The orientation of sails to the wind is controlled primarily by sheets, [8] but also by braces, which position the yard arms with respect to the wind on square-rigged vessels. [7]
11 – sheet 12 – boom 13 - mast 14 – spinnaker pole 15 – backstay 16 – forestay 17 – boom vang Stays are ropes, wires, or rods on sailing vessels that run fore-and-aft along the centerline from the masts to the hull, deck, bowsprit, or to other masts which serve to stabilize the masts. [1]
A high deck on the aft superstructure of a ship. The deck forms a roof over the "poop cabin" in the aft of the ship. [26] pooped 1. (of a ship or boat) to have a wave break over the stern when travelling with a following sea. [27] This contingency, that can cause significant damage to the ship, is also referred to as "pooping". [28] 2.