enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. FASTON terminal - Wikipedia

   en.wikipedia.org/wiki/FASTON_terminal

   The terminal system consists of tabs (male) and receptacles (female). There are free-hanging wire and circuit board mounted versions of both tabs and receptacles. All widths come mostly in one of two tab thicknesses: 0.032 and 0.020 in (0.8 and 0.5 mm). A hand tool exists for inserting the terminals: the AMP Universal Handle. [citation needed]

3. Wire gauge - Wikipedia

   en.wikipedia.org/wiki/Wire_gauge

   Each notch is stamped with a number, and the wire or sheet, which just fits a given notch, is stated to be of, say, No. 10, 11, 12, etc., of the wire gauge. The circular forms of wire gauge measurement devices are the most popular, and are generally 3 + 3 ⁄ 4 inches (95 mm) in diameter, with thirty-six notches; many have the decimal ...

4. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   The 20 A plug has a blade rotated 90° (opposite blade from what would be the "line" blade on a 2-15 or 5-15 plug. This prevents accidental insertion of plugs into outlets that use different voltages), and the 6-20R receptacle has a T-shaped hole to accept both 6-15P and 6-20P plugs (similar to the 5-20R receptacle accepting 5-15P and 5-20P plugs).

5. Reciprocating saw - Wikipedia

   en.wikipedia.org/wiki/Reciprocating_saw

   The original trade name, Sawzall, is often used in the United States, where Milwaukee Electric Tool first produced a tool of this type in 1951. [ 1 ] [ 2 ] The noun "Sawzall" is commonly applied to a smaller type of chargeable or battery-powered handheld saw used in construction and demolition work, as well as in gardening and the pruning of ...

6. American wire gauge - Wikipedia

   en.wikipedia.org/wiki/American_wire_gauge

   AWG is colloquially referred to as gauge and the zeros in thick wire sizes are referred to as aught / ˈ ɔː t /. Wire sized 1 AWG is referred to as "one gauge" or "No. 1" wire; similarly, thinner sizes are pronounced "x gauge" or "No. x" wire, where x is the positive-integer AWG number. Consecutive AWG wire sizes thicker than No. 1 wire are ...

7. Saw - Wikipedia

   en.wikipedia.org/wiki/Saw

   Set is the degree to which the teeth are bent out sideways away from the blade, usually in both directions. In most modern serrated saws, the teeth are set, so that the kerf (the width of the cut) will be wider than the blade itself. This allows the blade to move through the cut easily without binding (getting stuck). The set may be different ...